Will Replacement Manual Hand Crank for Ultra-Fab Twin II Stabilizer Fit Split Shaft
Question:
Do you know if it has that pin in middle like the motor to fit the split shaft. I don’t have the part numbers on me.
asked by: Todd
0
Expert Reply:
Yes, the Replacement Manual Hand Crank for Ultra-Fab Twin II Stabilizer # UF39-84-1641 has the pin in the socket on the end so it will be able to turn the shaft on the # UF39-941704.
expert reply by:
Robin H
0
Products Referenced in This Question
Ultra-Fab Power Twin II Manual Stabilizer for Trailers and RVs - 30" Lift - 6,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 5001 - 6000 lbs
- Electric Jack
- 30 Inch Lift
- Bolt-On
- 1 Jack
- Ultra-Fab Products
more information >
Product Page this Question was Asked From
Replacement Manual Hand Crank for Ultra-Fab Twin II Stabilizer
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Handles and Cranks
- Sidewind
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Replacement Manual Hand Crank for Ultra-Fab Twin II Stabilizer
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Q&A: Can I Use a Power Drill To Raise and Lower Ultra-Fab Power Twin II Manual Stabilizer
- Q&A: Replacement Grease Zerk for EZ Lube Spindle
- Q&A: Can Oil Bath Hubs be Converted to Grease Hubs
- Q&A: Can Lippert 8K Axle be Converted to Oil
- Q&A: How to Grease a Dexter EZ Lube Axle
- Q&A: Are Oil bath Hubs a Better Option for My 7,000 Lbs Axles Than Using Grease Hubs
- Q&A: Comparing Benefits of Greased Hubs vs Oil Bath Hubs