What is The Pin Diameter On The Buyers Products Spring Latch # BP34FR?

Question

Question:

what size is the pin? 1/2?

asked by: Glenn K

0

Expert Reply:

You are correct Glenn, the Buyers Products Spring Latch # BP34FR uses a 1/2" diameter pin.

expert reply by: Bud M

0

Answer 1

Trailer wiring generally uses 16 gauge wire, part #16-1-1. However, with a long trailer like yours you may want to go with a larger like 14 gauge #DW07550-1 or even 12 gauge #12-1-1. Each size is sold by the foot. You will need to have the lights at…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

It's a wire color difference but not a function difference on the pins of the 7-way. The difference comes from the fact that the two different styles are representative of two different areas that uses trailers. Traditional is usually seen on…

view full answer...

Answer 4

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

view full answer...

Answer 5

From what I could find online it looks like your Signal Stat 77-557 side markers are 4 x 2. We have some options from Optronics for you that have replacement bulbs and lens available. For Amber #MC38AB - Replacement Lens is #A38AB For Red #MC38RB -…

view full answer...

Answer 6

Yes. The Buyers Products Spring Latch - 3" Long x 1-3/4" Wide - Zinc Plated #BP34FR can be used as a left hand or right hand latch all the same.

view full answer...

Answer 7

Nope. The Spring Latch #F784-102Z you were looking at is not designed for either side, you just rotate it one way for being on the right side, and flip it 180 degrees to use it on the left side. I included a video of the #F784-102Z being installed…

view full answer...

Answer 8

There are a few things that can cause the brakes to lock up on a trailer. First, disconnect the trailer from the vehicle. Then use a circuit tester like #PTW2979 if needed to test the connector on the vehicle. Have someone sit in the truck and run…

view full answer...

Answer 9

I contacted our representative at Redline about the Bolt-On Stainless Steel Spring Latch, part #SL716SS. The bracket or base of the latch measures approximately 1-1/2 inches wide by 3-1/4 inches long and is 3/16 of an inch thick. The mounting holes…

view full answer...

Answer 10

The Roadmaster Direct Connect Base Plates #RM-521453-4 are going to install in the area that the skid plate is located, not on top of the bumper or in front of it, which is where I'm assuming most of winches are going to be mounted. If you've…

view full answer...

Answer 11

The inside dimensions of the #C83072 Curt Stake Pocket for Flatbed Trucks or Trailers are 3-3/4" long x 1-5/8" wide x 3" tall. A standard 2x4 measures 3-1/2" wide x 1-1/2" thick. Given these dimensions the 2x4 should fit…

view full answer...

What is The Pin Diameter On The Buyers Products Spring Latch # BP34FR?

Product Page this Question was Asked From

Continue Researching