RV Storage Cover For a Riverside Retro 135 Travel Trailer With Rear Entry Door

Question

Question:

I have a Riverside Retro 135 , a small trailer with a rear door. Is there a cover for it?

asked by: Donna O

0

Expert Reply:

While we do not have any covers with an opening for a rear door like you have on your Riverside Retro 135 you can still use the Adco SFS AquaShed RV Cover # 290-52238 to protect our camper when in storage.

expert reply by: Bud M

0

Answer 1

Your 2021 Buick Enclave has a wiring pigtail and not a connector for wiring a Redarc Tow-Pro Elite Trailer Brake Controller #RED44FR. The 4 wires are located below the OBD2 port behind the side kick plate(see Image). This is where you will be able…

view full answer...

Answer 2

There are several places water can get into any given jack. Water should be able to drain out though. If the exit points which would be at the lowest point are clogged then the water would not be able to exit. You could use a jack cover like…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Hey Jeremy, Typically with boat trailers the manufacturer will install hydraulic surge brakes because you don't have to worry about the water damaging wires like you would with electric brakes. That being said, if you use a heat shrink butt…

view full answer...

Answer 6

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 7

The Redarc Tow-Pro Liberty #RED24FR is the way to go over the Elite #RED44FR as you get the nicer functions of the Elite at a lower price. The Elite has the ability to be the more preferred proportional style of controller as well as a time-delayed…

view full answer...

Answer 8

You're right, the mounting bracket is unique (in a good way) for the Curt TriFlex NEXT Trailer Brake Controller #C24VV. The bracket is smaller and all you do is put the included adhesive tape on the bracket and stick it wherever you like under…

view full answer...

Answer 9

Hey HPA, I would go with the Air Lift kit part #AL64VJ that fits your 2019 Toyota RAV4 based on what you described and your needs. This gives you adjustable support that you can tailor as needed so that you get the exact amount of support you need…

view full answer...

Answer 10

Hey Antoine, so the two kits you mentioned are actually really similar and honestly I would go with the part #ETBC7 if I were you. The #ETBC7L is basically the same thing minus a couple wires and breakers so you may as well get the kit that has…

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 12

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

RV Storage Cover For a Riverside Retro 135 Travel Trailer With Rear Entry Door

Product Page this Question was Asked From

Continue Researching