Is It Safe To Connect a 30Amp Solar Controller To the 10Amp Furrion Charge Port?
Question:
I have a 2024 Prime Time Tracer that has a Furrion 10A charging inlet port, would there be any issue plugging the Go Power 200A kit with a 30A controller into it?
asked by: Paul
0
Expert Reply:
The Furrion Solar Port Inlet # FSPINS-BS is only rated for 10 amps of maximum input so if you somehow connected your Go Power to it this would most likely burn up the wiring since the controller is putting out up to 30 amps of 12 volt power. This connector was only designed to be used with a smaller portable panel typically a 100watts.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Solar Port Inlet for Furrion Solar Panel Battery Charger - 12-14V DC - Black
- Accessories and Parts
- Battery Charger
- Solar Port Inlet
- Furrion
more information >
Continue Researching
- Q&A: Replacement For 8,000 lb A-Frame Trailer Coupler With 2-5/16 Inch Hitch Ball
- Q&A: Will a Leveling Kit on a 2016 Ford F-150 Affect the RoadActive Suspension Kit?
- Q&A: Rear Helper Springs/Suspension Enhancement for a 2018 Chevy Colorado ZR2 Diesel
- Q&A: Replacement Trailer Clearance Lights PM-108-15 SAE-AP2-79
- Q&A: Replacement Hitch Connector Assembly For Blue Ox Ascent or Avail Tow Bars
- Article: Best Bike Racks for Electric Bikes
- Article: Trailer Wiring Diagrams
- Q&A: Correct Replacement for Tru-Ryde Hub/Drum RVD-H-545
- Q&A: Replacement Inner Tank for Atwood 91641
- Article: How to Measure for Trailer Hitch Drop
- Article: How Much Solar Power Do I Need For My RV?
- Article: How (and Where) to Connect an RV Propane Grill
- Article: Trailer Maintenance Schedule
- Article: Brake Controller Installation: Starting from Scratch