Troubleshooting Weak Trailer Brake Assemblies
Question:
replaced brake assemblies and braking is weak could it the hubs
asked by: SMITH P
0
Expert Reply:
Its possible the hubs but I would make sure the new assemblies are properly adjusted and also worn in initially. You will want to have a light drag on the assemblies you can feel as you turn the wheel by hand.
Also make sure your assemblies are wired up with 10 gauge wire like the part # 10-1-1 and that the drums aren't worn past the thickness they have listed on them or have grease in them.
expert reply by:
Jameson C
0
Products Referenced in This Question
Product Page this Question was Asked From
Dexter Electric Trailer Brake Assembly - 10" - Right Hand - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- RH
- 3500 lbs
- Brake Assembly
- Manual Adjust
- 10 x 2-1/4 Inch Drum
- Dexter
more information >
Continue Researching
- Q&A: Replacement Dexter Brake Assemblies for 36-19 Assemblies
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Dexter Trailer Brake Kit To Replace Dexter 36-19 Brake Assemblies
- Q&A: Replacement Hub and Brake Assemblies that Fit Sure Trac 3,500 lb Axle
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Recommended Wet Bolt For Center Hole Of The CRE 3000 Equalizer
- Q&A: Replacement Bolt and Nut for MORryde Wet Bolt Kit part # MR46ZR
- Q&A: Replacement Hub for a Lippert LCI 126003 Hub
- Q&A: How to Initially Adjust the Dexter Nev-R-Adjust Electric Trailer Brakes
- Article: Trailer Tire Sizing
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: How to Choose the Right Trailer Hitch Class