Can the 7 Voyager WiSight Monitor Be Swapped With the 4.3 Monitor

Question

Question:

Will this work with the stock backup camera on a 2020 Airstream Bambi 16RB? The original monitor was definitely a Voyager brand and I think with more like a 7” screen

asked by: Serge

0

Expert Reply:

If your original monitor was in fact the Replacement Voyager WiSight 2.0 Wireless RV Backup Camera Monitor # ASA27FR then yes you can use the Replacement Voyager WiSight 2.0 Wireless RV Backup Camera Monitor # ASA87FR as a replacement.

If this is not your exact monitor, then you'd just have to let me know a little bit more info on what cameras you have so I can see what options we have for you.

expert reply by: Bryce D

0

Answer 1

You will need to replace your entire system as the Voyager WiSight WVOM541AP is obsolete. I recommend upgrading to the Voyager WiSight 2.0 Wireless Backup Camera System #ASA37YR. While these are both WiSight systems the 2.0 and original WiSight are…

view full answer...

Answer 2

The ball joint that comes with the suction cup mount for the Replacement Voyager WiSight 2.0 Wireless RV Backup Camera Monitor #ASA87FR has a 3/4" diameter according to my contact at ASA Electronics.

view full answer...

Answer 3

Here's the pairing process for the WiSight camera kit for you to try: PAIRING PROCESS This system contains an Auto-Pairing function. If your monitor is not receiving a signal from the camera; the two may not be paired correctly. 1. Make sure the…

view full answer...

Answer 4

The Trailer Leaf Spring, 2250 lbs. 6 Leaf, item #e27SR, is sold as a replacement spring for older trailers and measures 26 inches for eye to eye, center to center. If you are replacing the springs and hangers you will need to use the same center to…

view full answer...

Answer 5

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 6

The installation instructions for this product are recommended for individuals who have experience winding torsion springs. If you have not worked with a torsion spring system before, we recommend contacting a local garage door company to install…

view full answer...

Answer 7

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 8

Since the issue appears to be on the vehicle side for your 2017 Toyota Tacoma, I recommend first checking the connector itself. Look to see if there is any dirt or corrosion built up inside the connector that may preventing a solid connection with…

view full answer...

Answer 9

Hi Jeremy; that's a good question and you'll actually need to go ahead and re-do the set up of your weight distribution system after adding the Timbren Rear Suspension Enhancement System #TDR1500DS to your 2019 Ram 1500. So it wouldn't…

view full answer...

Answer 10

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 11

Since your trailer has the bracket #FRCBRKT-BL that would mean your trailer has the Furrion pre-wiring which is very common for newer RVs. The part #FOS43TASF is a fit for this and would be a really easy install. This gives you a monitor with a 4.3…

view full answer...

Answer 12

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Can the 7 Voyager WiSight Monitor Be Swapped With the 4.3 Monitor

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching