Distance From Center of Hitch Pin Hole to Support Gusset on Brophy Drawbar for 1-1/4" Hitches
Question:
Due to restrictions of the rear bumper i.e. interference I need to know the following measurement: 1. What is the measurement in length, from the center-holeinch where pin is ed, TO where the added welded-in support metal piece begins i.e. side of support metal piece, closest to the center-hole for the pin. Why? Because I need to install as a riseinch and if not enough distance exists, then my rear plastic bumper 2002 Pontiac Bonneville-SE will prevent the install of the Brophy Drawbar for 1-1/4inch Hitch 5 1/2inch Rise. Thank you
asked by: Mark B
Expert Reply:
The distance from the center of the hitch pin hole to the closest part of the support gusset on the Brophy Drawbar for 1-1/4" Hitches # BM96 is 3".
Product Page this Question was Asked From
Brophy Drawbar for 1-1/4" Hitches - 5-1/2" Rise, 6" Drop - 7-1/4" Long - 3.5K
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 3/4 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Drop - 6 Inch
- Rise - 5 Inch
- Fits 1-1/4 Inch Hitch
- 3500 lbs GTW
- Class II
- Brophy
more information >
Continue Researching
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Recommendation for 1-1/4 Inch Ball Mount with 8 Inch Rise
- Q&A: Recommended 33-1/4 Inch Cam-Door Lock for Enclosed Trailer
- Q&A: Why Aren't Adjustable Ball Mounts Made for 1-1/4 inch Trailer Hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Tire Sizing
- Article: Flat Towing Package for 2018 Jeep Wrangler JL and JL Unlimited
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: How to Carry Bikes With 2018 Honda Civic Hatchback With Center Exhaust
- Q&A: Highest Rise Ball Mount for 1-1/4" Trailer Hitch Receiver
- Q&A: Correct Trailer Hitch Fit for a 2006 Scion xB
- Q&A: Hitch and Wiring Recommendation for a 2006 xB
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: How to Choose the Right Trailer Hitch Class