Differences Between Aries Replacement Step Pads # AA2090161 and # AA2090133

Question

Question:

what is the difference between AA2090161 and AA2090133 i need to replce once on my truck but not sure which model they both are same width and length and both have 4 pins

asked by: Michelle L

0

Expert Reply:

I do see the back of the Replacement Step Pad # AA2090161 has 8 ribs while the back of the Replacement Step Pad # AA2090133 has 10 ribs.

expert reply by: Bud M

0

How to Tell Difference Between Replacement Step Pads for Airies Automotive AAS224046-2 Oval Step Bars
(click to enlarge)

Answer 1

Actually, if you look closely the #AA2090161 has 4 pegs and a center pin used to align the step. Aries tells me that the #AA2090161 is indeed the proper replacement step for their 4 inch wide oval step bars. I've provided a photo showing…

view full answer...

Answer 2

While we have options for you, the pads with 4 holes you asked about, the Replacement Step Pad for Aries 4" Wide Oval Nerf Bars #AA2090133 will not work as replacements. The option that may work is the Replacement Step Pad for Aries…

view full answer...

Answer 3

The Replacement Step Pad for Aries 4" Wide Oval Nerf Bars #AA2090133 are longer than the ones that you currently have. The overall length is 23-5/8" long. The center 2 pegs are 12-5/8" apart on center and the outer pegs are another…

view full answer...

Answer 4

For the Replacement Pads you are seeking, it sounds like you have the 4-inch Wide Oval steps. If that is the case then the replacement is #AA2090161.

view full answer...

Answer 5

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 6

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 7

I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit #BD1824200100 to the slave jack itself. He also said that if you need to switch the motor wires to make it work correctly, that would be fine, as…

view full answer...

Answer 8

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

view full answer...

Answer 9

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 10

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Answer 11

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 12

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Differences Between Aries Replacement Step Pads # AA2090161 and # AA2090133

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching