Troubleshooting Signal Loss With A Furrion Vision S Camera System
Question:
We have been using Our Furion backup camera for the past 3 years. For some reason it has lost signal to the monitor. I have double checked the wiring and it looks like power is going to the camera as the blue light is on. I have also double checked and plugged the camera in the power cord adapter and you do get the picture on the monitor. I have also re-linked the camera to the monitor. When we re-install the camera to the trailer, we are not getting a picture on the monitor. Any ideas on what the issue may be? Thanks
asked by: Robert M
Expert Reply:
If your Furrion Vision S Camera System # FOS43TASF is working when connected to the monitor wire but not when connected to the rear of the trailer then you most likely have a power issue. The camera needs 12 volts to properly operate but the blue light will activate with less voltage. Most likely the tow vehicle isn't putting enough voltage out to power the entire circuit (lights, camera, etc.) so the camera isn't getting enough voltage to actually operate and pair to the monitor correctly. You can check this with a multimeter # PT89ZR at the camera.
To solve the power issue you'll just need to splice in a PWM Filter # VGR64VR behind the camera to provide a constant 12 volts. This filter comes with butt connectors already on the wires so it's a very simple installation. I've attached a short video below where I'll walk you through the process.
Products Referenced in This Question
Digital Multimeter with 42" Long Test Leads - LED Display
- Electrical Tools
- Testers
- Multimeter
- Yellow
- Performance Tool
more information >
12V PWM Filter for RV Backup Camera Systems - Hardwire
- Accessories and Parts
- Backup Camera
- RV Camera System
- Cables and Cords
- Power Line Filter
- Voyager
more information >
Product Page this Question was Asked From
Furrion Vision S Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 4.3" Screen
- RV Camera System
- Backup Camera
- Observation Camera
- Built-In Microphone
- Touch Screen
- Anti-Glare
- Mirrored Image
- Night Vision
- Motion Detecting
- Waterproof
- Wireless Signal
- 120 Degrees
- Dashboard Mounting Bracket
- Suction Cup Mount
- Below Rear Clearance
- 4.3 Inch Display
- 1 Camera
- Furrion
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Level Your Fifth Wheel in 3 Simple Steps (Manual or Auto-Level)
- Q&A: Weak/Intermittent Signal Error With Furrion Vision S Wireless RV Backup Camera System
- Q&A: Camera Kit for RV that has Furrion Bracket Mounted on Rear # FRCBRKT-BL
- Q&A: Can The B&W Continuum Weight Distribution System Be Installed When on a Sloped Driveway?
- Article: How to Choose a Bike Rack for a Motor Home or RV
- Q&A: Which 5th Wheel Hitch Is Needed for a 2024 Chevy Silverado 2500 w/ a 6-3/4 Foot Bed and Puck System?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: Correct Backup Camera for Forest River Rockwood Mini Lite Travel Trailer
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: How Much Solar Power is Needed for Refrigerator in 2020 Brookstone 310RL
- Article: Trailer Wiring Diagrams
- Q&A: Can 45 Amp Go Power Converter/Charger be Used to Replace 40 Amp Converter/Charger on Trailer
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: How to Carry Bikes While Towing a Travel Trailer