bing tracking image
Q & A Icon

Troubleshooting Intermittent Signal Loss With A Furrion Vision S RV Camera System  

Question:

My Furrion camera works, but the signal sometimes will cut out completely for a few seconds and then come back on. This happens every few min.

0

Expert Reply:

If you're consistently losing service with your Furrion Vision S Camera System # FOS43TASF you could either have a loose/damaged antenna or a power issue. Check to make sure your antenna # 772577 is fully screwed onto the camera and facing up to provide the best path to the monitor.

The other likely suspect is that the camera system is wired into a light circuit that's pulling a bit too much for the camera system to properly operate. To provide consistent power to the camera you can install the PWM Filter # VGR64VR. This will splice in just behind the camera and provide a constant 12 volts. I've attached a video below where I'll walk you through the installation process.

expert reply by:
0
Kevin C

Products Referenced in This Question



Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>