Can Furrion Vision S with Side Cameras Install on 2018 Coachman Apex Travel Trailer

Question

Question:

I have a 2018 Coachman Apex travel trailer. Its pre-wired for Voyager backup camera. Id like side cameras too. Ive been looking at Furion system with marker light cameras. My question,, will the pre wired plug work with Furion or is there an adapter? Or, Can I use the Furion side marker cameras with Voyager WiSight 2.0 monitor?

asked by: George A

1

Helpful Expert Reply:

You can use the Furrion Vision S with Side Cameras kit part # FCE48TASL-05 on your Coachman Apex travel trailer that was pre-wired for a Voyager but there isn't an adapter available. Instead all you'd need to do is remove the wiring to the current connector and run it to the wiring of the Furrion. Basically the connector has a running light and ground circuit to it which you'd then need to match to the Furrion.

The Furrion side cameras would not work with the Voyager rear camera.

expert reply by: Jameson C

1

Answer 1

If you replace the OEM Brake controller of your 2016 Toyota Tundra with the Prodigy P3 part #90195 and install harness part #3031-P you would just need to disconnect the vehicle battery for a minute or so to prevent any dash error codes.

view full answer...

Answer 2

With this problem the issue is almost always that the pins of the 7-way need to be cleaned with sandpaper. The brake controller output circuit on the 7-way is the 5:00 position of the vehicle side.

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

While we do not carry that particular Lippert step we do have the similar MORryde #MR98RR or a better option in my opinion is the TorkLift GlowStep #TLA9104. I prefer this step as it folds up nicely and works better in tight areas like storage lots.…

view full answer...

Answer 5

The Furrion camera system we have is a closed system and would not be compatible with the in-dash display so you would need to purchase GM's camera system to be able to connect to your display instead of having another monitor. If you do end up…

view full answer...

Answer 6

The Greystone 26" Electric Fireplace with Crystal #324-000069 is the direct replacement for the F2625.

view full answer...

Answer 7

I have a solution for you because as you know what you have now cannot charge Lithium batteries. You will need the Progressive Dynamics #PD4135K which is designed to replace your WF-8735P and is compatible with Lithium batteries. When this is…

view full answer...

Answer 8

If your switch is illuminated then I do believe that 3rd terminal is for the backlight. For a replacement I recommend checking out the Single Rocker Switch - 12V - On/Off - SPST - Black Plate with Red Illuminated Switch #37212525. Attached is a…

view full answer...

Answer 9

Yes, the Replacement 7" Monitor #FR47FR will indeed be compatible with your Furrion camera system with the FCE48TASH side marker cameras. The FCE48TASH is basically Furrions newest most recent camera model, so the new monitors are undoubtedly…

view full answer...

Answer 10

Though the Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs #F2709 will offer you more support when fully loaded, they will also affect your ride a lot more when not loaded. Even at the lowest setting (5 psi). I really only recommend…

view full answer...

Answer 11

Hey David; I checked directly with Pace Edwards for you and can tell you that the rails on the Pace Edwards Switchblade Retractable Hard Tonneau Cover #PE46QJ will protrude just under 3/4" on both sides when installed on your Ford Super Duty…

view full answer...