Will Air Lift Coil Springs Work on Lifted 2013 Jeep Wrangler

Question

Question:

Will this work on a 4” lifted 2013 jk?

asked by: Tony

0

Expert Reply:

So long as the coils are not different on your lifted 2013 Jeep Wrangler then yes, you can use the Air Lift 1000 Air Helper Springs for Coil Springs - Rear # AL60817.

expert reply by: Kyle S

0

Answer 1

The Air Lift AirLift 1000 Air Helper Springs for Coil Springs - Rear #AL60817 can utilize spacers to compensate for a lift kit installed on the vehicle. I reached out to my contact at Air Lift and they need the internal diameter of the coil as well…

view full answer...

Answer 2

Yes, I checked with Airlift and the Airlift 1000 Air Helper Springs #AL60817 that you referenced are confirmed to fit your 2013 Jeep Wrangler Rubicon.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

Yes we do have a set of Timbrens that fit your 2024 Toyota Tundra with the part #T45MR. These can give you up to an additional 6,000 lbs of suspension support.

view full answer...

Will Air Lift Coil Springs Work on Lifted 2013 Jeep Wrangler

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching