Which Line Going to the Radiator of a 2008 Chrysler Town and Country is the Supply Line

Question

Question:

is the upper or lower line going to the radiator the high pressure line

asked by: Mark

0

Expert Reply:

The best way to determine which transmission line is the high-pressure or supply line and which is the return line is to start the motor cold. Place the transmission in drive for 10 seconds and return it to park. Turn off the motor and feel both transmission lines where they exit the radiator. The cooler of the two lines will be your return line, the warmer line is your supply line.

I have included a diagram of a typical transmission cooler installation.

To see a typical install video, click on the provided link.

expert reply by: Chris O

0

click to enlarge

Answer 1

The Derale Series 8000 Plate-Fin Transmission Cooler Kit #D13501 will absolutely fit your 2017 Chevy Colorado without any type of 90 degree adapters. The key is just ensuring the correct length of hose; that is a pretty open area so you will have…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Hey Jimmy! It looks like the Vantage Mobility Northstar Packages don't alter the rear end of the 2015 Honda Odysseys. You will want to confirm this because all of our available hitches are set up for unaltered factory set ups. If this is the…

view full answer...

Answer 5

Check out the picture I attached that shows the instructions sheet for this Surco Safari Rooftop Cargo Basket #SPS4550-1101. You should not need any additional brackets to complete the installation. Once assembled the clamps from the cargo basket…

view full answer...

Answer 6

Hey Jerry, the install of the Aries Bull Bar part #AAB35-4015 do require you to permanently remove the tow hooks to install. It looks like the similar Westin Ultimate Bull Bar part #32-3645 does allow you to keep them though.

view full answer...

Answer 7

For your 2017 Honda Odyssey the transmission cooler I recommend is the Derale part #D13503 which is large enough and efficient enough to do a great job prolonging the life of your transmission. It measures 11" Wide x 8-3/4" tall x 7/8"…

view full answer...

Answer 8

You can install a stack cooler in your vehicle. The Class ratings are there as a reference point to a hitch Class. For example if someone has a Class III hitch they can look at coolers, see a Class III and say, hey, I have a Class III hitch so this…

view full answer...

Answer 9

If you were going to ask for a transmission cooler recommendation for a 2019 Jeep Grand Cherokee then I would recommend the Derale Series 8000 Plate-Fin Transmission Cooler Kit part #D13502 which is going to be the perfect size. The Flex-a-lite…

view full answer...

Answer 10

The Flex-a-lite Transmission Cooler #FLX400117 does come with everything needed to install. No other components would be needed.

view full answer...

Answer 11

The Class rating applied to transmission coolers is to help simplify choosing a cooler for a vehicle. Basically you would think about it in terms of a hitch class rating. So for example if your 2007 Toyota FJ Cruiser has a Class III hitch then a…

view full answer...

Answer 12

The Yakima HD Crossbar Set, part #Y01157, have a weight capacity of 500 lbs in conjunction (i.e. the two of them together can hold 500 lbs). The reason the single bar, part #YA34FR, states that its weight capacity is 500 lbs because these bars are…

view full answer...