Replacement Trailer Hub Seal that has Inner Diameter 1.68 inches and Outer Diameter 2.33 inch

Question

Question:

I need four wheel seals for an old ag trailer with inner diameter, 1.622inch and outside diameter 2.325inch Can you help?

asked by: Mike K

1

Helpful Expert Reply:

The closest option we have that would work is the part # 010-180-00 which has an inner diameter of 1.68 inches and an outer diameter of 2.33 inches.

expert reply by: Jameson C

1

Answer 1

There are two different ways to determine which replacement bearings and grease seals will fit your boat trailer. The first is removing the hub and looking for the bearing numbers stamped on the face of the bearing as shown in the included picture of…

view full answer...

Answer 2

Pulling the wheels and hubs off of your 5th wheel trailer is the best option when trying to identify what wheel bearings and seals are installed. On the back of the wheel bearings there usually is printed a part number like #L44643. With these…

view full answer...

Answer 3

If the rear axle trailer tires are supporting more of the weight of the trailer then they would wear out faster. There are couple of adjustments that could be made to try to even out the load on the trailer. The first would be to more evenly…

view full answer...

Answer 4

A wider tire will not solve the issue of your tires wearing down on the inside only. If your trailer tire is wearing on the inside but is not overloaded and your suspension is aligned properly the only other issue that can be causing this is the…

view full answer...

Answer 5

You can align trailers. Basically to see if it is off, measure from the center of the coupler diagonally to the center of the end of the spindle. Then do the same on the other side. Make sure to measure from the same spot on the coupler to the same…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Since your 2023 Jayco travel trailer has an underslung coupler, you would want the B&W Continuum Weight Distribution System w/ Sway Control item #BW88FR. The Continuum item #BW78FR you were looking at is for standard couplers. It sounds like you…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

To select the correct B&W Continuum Weight Distribution System for your needs you will first need to determine if you have a standard coupler(mounts on top of trailer frame rails) or an underslung coupler(mounts on the bottom of the trailer frame…

view full answer...

Answer 11

The B&W Continuum Weight Distribution System part #BW78FR won't allow for the tailgate to open fully as it ships. In order for this to happen you'd need to switch out the shank for a longer option which is still currently being developed…

view full answer...

Answer 12

The closest option we have that would work is the part #010-180-00 which has an inner diameter of 1.68 inches and an outer diameter of 2.33 inches.

view full answer...

Replacement Trailer Hub Seal that has Inner Diameter 1.68 inches and Outer Diameter 2.33 inch

Product Page this Question was Asked From

Continue Researching