Does Polar Hardware Strap Hinge Use Rivets and Screws for Installation

Question

Question:

Are the hinges secured with rivets and screws.

asked by: Steve L

0

Expert Reply:

The Strap Hinge # PLR104SS can use rivets, screws, or any other hardware you want to use as long as it fits the holes on the hinge. It is pre-drilled to accept #10 screws which have a 0.190" thread diameter.

expert reply by: Robin H

0

Strap Hinge Measurements on Trailer
(click to enlarge)

Answer 1

Due to the fact that carbon fiber bikes have a more sensitive frame, Thule does recommend using the Thule UpRide #TH599000. Bike rack technology has not changed to make the racks less compatible, but carbon fiber bikes have become increasingly…

view full answer...

Answer 2

The Demco Hijacker Autoslide 21K #DM8550038 weighs approximately 305-lbs. The head of this hitch weighs around 70-lbs and can be removed to help make moving and installing this 5th wheel hitch a little bit easier.

view full answer...

Answer 3

The first thing to do is disconnect the trailer from the Liberty. Then using a circuit tester, like part #PTW2993, test each pin of the 4-Way. Clip the alligator clip of the circuit tester to the exposed post, the ground wire. Check each pin with…

view full answer...

Answer 4

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 5

I checked with Curt and they do show the Curt Trailer Hitch Receiver part #C13233 as a fit for a 2022 Volvo XC90 All Models which includes the Recharge.

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…

view full answer...

Answer 8

Since the issue appears to be on the vehicle side for your 2017 Toyota Tacoma, I recommend first checking the connector itself. Look to see if there is any dirt or corrosion built up inside the connector that may preventing a solid connection with…

view full answer...

Answer 9

Is the battery of the breakaway kit charged? Does your tow vehicle have a brake controller installed?

view full answer...

Answer 10

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 11

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 12

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Does Polar Hardware Strap Hinge Use Rivets and Screws for Installation

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching