Inner and Outer Diameters of Pipe Mount Piece for Bulldog Square Swivel Jack w/ Round Pipe Mount

Question

Question:

Hello Sir, Im replacing the trailer jacks and Id like to know the outter and inner diameters of the pipe mount on the jack side of a Bulldog trailer jack Item # BD190758. regards

asked by: Tom L

0

Expert Reply:

The jack-side pipe mounting piece from the Bulldog Square Swivel Jack w/ Round Pipe Mount # BD190758 has a 2" inner diameter and a 2-1/2" outer diameter.

expert reply by: Jon G

0

Answer 1

I pulled the Bulldog square swivel jack #BD190758 from our warehouse to provide the measurements you requested. The jack is 26-inches in overall length, not including the handle. The handle radius is 8-1/2 inches for your reference. If the foot…

view full answer...

Answer 2

The support capacity is how much a jack can hold whereas the lift capacity is how much a jack can lift. The Bulldog Square Jack w/ Footplate part #BD190754 has a 8,000 lb support and 5,000 lb lift capacity. If you will be using the jacks to lift…

view full answer...

Answer 3

Pipe mount #BD005024 is the correct match for Bulldog jack #BD190758. The mating end on the jack fits inside of this mount which gets welded to the trailer frame. I have linked a video of the mount for you.

view full answer...

Answer 4

I went out into our warehouse and to measure one of the Bulldog Square Swivel Jacks #BD190758 we had in stock and found that the inner diameter of the female mount is 2-17/32 inches and the outer diameter of the male pipe mount on the body of the…

view full answer...

Answer 5

The Bulldog 3" Long, Weld-On Jack Pipe Mount #BD003155 is generally used for the installation of trailer jacks like the #BD190758. The other side of the mating part is permanently attached to the jack. The matching pin is on the jack as well.…

view full answer...

Answer 6

The Ark Drop Down Corner RV Stabilizer Jacks #ARK94FR are able to lock into place at 30 and 60 degrees as stabilizers. They also have the 90 degree position where it is rated for 1,929 lbs and then the stored position.

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Inner and Outer Diameters of Pipe Mount Piece for Bulldog Square Swivel Jack w/ Round Pipe Mount

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching