What are the Erickson Horseshoe Rope Cleats - 2 Pack, # EM09090, Made Of

Question

Question:

Are these Aluminum?

asked by: Tom D

0

Expert Reply:

No, the Erickson Horseshoe Rope Cleats (2 Pack), item # EM09090, are constructed of chrome plated steel, not aluminum. I went to the warehouse and pulled these to be sure. I checked the quality of the construction, they are very high quality and heavily built.

expert reply by: Robert G

0

Answer 1

The gap between the sides and the center of the cleat and the center of the cleat and the mounting surface is exactly 3/4 of an inch. If the rope used was pretty flexible, you might be able to get 3/4 inch diameter rope through there, but in all…

view full answer...

Answer 2

I went out to the warehouse to measure a Erickson Horseshoe Rope Cleats (2 Pack), #EM09090. It is 3 inches wide, outside diameter, at the widest point. It is 2 inches wide, inside diameter, at the widest point. The mounting holes are 2-5/16 inches…

view full answer...

Answer 3

The Erickson Horseshoe Rope Cleats (2-Pack), part #EM09090, have three mounting holes in each and include Phillips-head mounting screws. I pulled a sample from our warehouse to take precise measurements of the mounting holes. Please refer to the…

view full answer...

Answer 4

I pulled a sample from our warehouse to take precise measurements of the mounting holes. The distance between either of the bottom of the horseshoe are spaced 1-7/8 inches apart. The distance between either of the bottom holes and the middle/top…

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The…

view full answer...

Answer 6

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on…

view full answer...

Answer 7

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 8

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to…

view full answer...

Answer 9

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack…

view full answer...

Answer 10

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 11

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Answer 12

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need…

view full answer...

What are the Erickson Horseshoe Rope Cleats - 2 Pack, # EM09090, Made Of

Product Page this Question was Asked From

Continue Researching