Replacement Manual Crank Handle For Buyers Products Electric Tongue Jack

Question

Question:

Hi, Im looking for a manual crank handle for my electric tongue jack. It appears that most tongue jacks have a nut that actuates the manual override but the fitting on this one is different.

asked by: James

0

Expert Reply:

It appears you have the Buyers Electric Trailer Jack # 3370093500 based on the design and shape of the override crank. It appears you will need to find one of these used as Buyers does list them available separately. You may be able to use the Crank Assembly # TV0006 with a bit of modification if you are unable to find a replacement.

expert reply by: Bud M

0

Electric Jack Override
(click to enlarge)

Electric Trailer Jack
(click to enlarge)

Answer 1

Yes, we have the Replacement Control Knob #RED57FR for your Redarc Tow-Pro Liberty Electric Trailer Brake Controller #RED24FR.

view full answer...

Answer 2

The tire size ST205/75-15 like part #TR20515D will fit in place of a 7.00-15 as the widths are very similar but the tire height will be about 2 inches shorter overall.

view full answer...

Answer 3

It sounds like you're saying it is hooked up to power but it doesn't have the ability to raise the trailer. This could be the batteries or a problem with the wiring. It is probably getting power, it just may not be enough to lift the trailer.…

view full answer...

Answer 4

For your application there really is only going to be a weld on solution that's reasonable like the part #UF48-979022 that you referenced. The frame dimensions are unknown so a weld solution would be better since that really doesn't matter.…

view full answer...

Answer 5

Yes, you can use a dolly like the #RA20 with a smaller hitch ball to move around a trailer that has a larger hitch ball. The trailer's tongue weight will keep the trailer on the ball and it will be totally fine and safe.

view full answer...

Answer 6

The powered a-frame jack I recommend for a 6,800 lb trailer like yours is the Stromberg Carlson 5,000 lb powered jack part #JET-5000 that you referenced. This jack has more than enough capacity for your 6,800 lb trailer that would have 680 lb of…

view full answer...

Answer 7

The Electric Jack w/ Footplate and 7-Way Plug - A-Frame #EJ-3527-BBX should stop before it reaches the pin and clip that holds the drop leg. Most people will typically stop as soon as they're a few inches above the ground to avoid having to wait…

view full answer...

Answer 8

The Curt MV Weight Distribution System #C17062 comes with a 2-5/16" hitch ball that has a shank with a 1-1/4" diameter.

view full answer...

Answer 9

I'd recommend the 3-Leaf Double-Eye Spring for 4,000-lb Trailer Axles part #e57SR which measure 25-1/4" long and have a bit more capacity than your standard 3,500 lb spring so they won't wear out as fast. This means you must also replace…

view full answer...

Replacement Manual Crank Handle For Buyers Products Electric Tongue Jack

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching