Which Wires on the Ventline Ventadome Roof Vent w/12V Fan and Wall Switch are Grounds

Question

Question:

CAN YOU TELL ME WHICH OUT GOING OF THE FOUR IS GROUND

asked by: JESUS P

0

Expert Reply:

On the Ventline Ventadome wall switch part # V2119-3-533 the white wires are the ground wires. Both of the switches need to be grounded.

expert reply by: Jameson C

0

Answer 1

You can utilize a power wall remote switch #VC0533-03-A or #VC0533-02-A (black or white). A rocker switch #BL0108-00 will work and you will need 2 of them. The installation kit #344270KITW will come with screws, tape, and sealant. You will also need…

view full answer...

Answer 2

Correct, the Ventline Ventadome Roof Vent w/ 12V Fan with Powered Lift, #V2119-603-00 will require use of the Wall Remote Switch for Ventline Ventadome Roof Vent, #VC0533-03-A in white, or VC0533-02-A for black face plate. The Ventline Ventadome,…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 7

Tracks can absolutely be installed on the roof of your A.R.E. Truck Cap to provide a mounting system for a roof rack. For this I recommend the Yakima Tracks, which come in 42 inch #Y01126, 54 inch #Y01127, and 60 inch #Y01135 lengths. These tracks…

view full answer...

Answer 8

For a roof rack to be compatible on your 2020 Jeep Wrangler with Sky One-Touch Power Top, it can't be mounted on the top of the roof and it needs to be high enough for the folding roof to clear. What you need are tall gutter-mounted roof racks.…

view full answer...

Answer 9

The Rhino-Rack Roof Rack for Factory Tracks #Y02-490B-NT is going to be your best bet for the tracks on the ARE topper for your 2012 Toyota Tacoma. The weight capacity is 220 lbs like you mentioned, but that's going to be the highest you'll…

view full answer...

Answer 10

Yakima's Skyline towers part #Y53TR can fit the tracks of the Retrax XR that you have with the landing pad 1 part #Y00221 but there isn't a way with the Baseline towers. Your Yakima Corebar or Jetstream bars will work with the Skyline towers…

view full answer...

Answer 11

Hi Steve, thanks for the question, and we do indeed have the correct mounting panel for the Redarc Tow-Pro Liberty #RED24FR on your 2007 Toyota Tacoma. What you need is the following: - Mounting Panel for Redarc Tow-Pro Trailer Brake Controller…

view full answer...

Answer 12

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Which Wires on the Ventline Ventadome Roof Vent w/12V Fan and Wall Switch are Grounds

Product Page this Question was Asked From

Continue Researching