Troubleshooting Reverse Light Fuse Blowing and Reverse Lockout Solenoid Wiring getting Hot
Question:
Reverse light circuit for reverse lock out is blowing...My ground wire going to trailer is getting hot when this happens my surge brake fuse blows ! What could be blowing this I changed my solenoid should have I put Teflon tape on the threads thanks
asked by: Tommy G
Helpful Expert Reply:
It sounds like the problem is in the wiring of your reverse lockout solenoid. Most likely the circuit is shorting out somewhere and is causing the circuit to over-draw which is why the fuse is popping and the wire is getting hot.
I would inspect the wiring of the circuit and see if you can find any obvious signs of a short and fix as necessary. Cut or exposed wiring or corrosion can cause shorts.
I attached an FAQ on trailer wiring for you to check out also.
Product Page this Question was Asked From
Demco Hydraulic Drum Brake Assembly - Single Servo - Galvanized - 10" - Right Hand - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Hydraulic Drum Brakes
- RH
- 3500 lbs
- Brake Assembly
- Single Servo
- 10 x 2-1/4 Inch Drum
- Demco
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Troubleshooting Trailer Wiring That Blows Fuse When Put in Reverse
- Shop: Trailer Wiring
- Search Results: e99011
- Q&A: Ways To Convert A 5 Way Boat Trailer Plug To 7 Way
- Q&A: Vehicle Blows Fuse When Trailer is Attached
- Q&A: Wiring Diagram for Installing Junction Box Upgrade to Utility Wiring Colors
- Q&A: Troubleshooting Surge Brakes Locking up When in Reverse
- Q&A: Troubleshooting Trailer Surge Brakes That Activate in Reverse with New Truck
- Shop: Replacement Consumer Lockout Key for Dexter Axle Brake Actuators - Qty 1
- Shop: 7-Way Round RV Style Trailer Connector - Trailer Side
- Shop: Replacement Solenoid Valve for Dexter Brake Actuators with Reverse Lockouts
- Shop: Curt Powered Tail Light Converter w/ 4-Way Flat Trailer Connector and Install Kit
- Search Results: dexter brake line
- Shop: Hydraulic Flex Hose - 18" long
- Shop: Dexter Hydraulic Brake Line with Fittings - 25" Long
- Shop: Kodiak Hydraulic Brake Hose - 3/16" Male Fittings w/ Stainless Flares - 1/8" ID - 1.5'
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Video: Choosing the Right Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: 44649
- Shop: Trailer Hitch
- Search Results: 68149
- Shop: Brake Controller
- Video: Choosing the Right Brake Controller
- Article: How to Choose the Right Trailer Hitch Class
- Search Results: 25580
- Shop: Fifth Wheel Hitch
- Video: Tow Ready 4-Pole Mounting Bracket Installation
- Video: Brake Buddy Classic 3 Portable Supplemental Braking System Installation - 2009 Jeep Wrangler Unlimit