Does TorkLift PowerArmor Solar Locking Battery Box Need Charge Controller

Question

Question:

Does this have a built in charge controller? Without it can it over charge the battery or batteries? I have a solar system on my camper and I have to have a charge controller to mange the battery charge.

asked by: Shawn

0

Expert Reply:

The Torklift Power Armor Solar Tool Box part # TLA7708RS does not have a charge controller built into it as it puts a light enough charge on the battery that it can't overcharge it.

expert reply by: Jameson C

0

Answer 1

Our range of trailer battery boxes is shown on the linked page. These include standard plastic and metal boxes as well as ones with built-in solar chargers to help maintain your battery power level, such as TorkLift #TLA7708RS which measures 26-3/4…

view full answer...

Answer 2

To avoid having to drill holes in the trailer frame you could use u-bolts to go around the frame so you are only drilling holes in the bottom of battery box #TLA7708RS. Otherwise you would have to drill into the frame. To connect two 6 volt batteries…

view full answer...

Answer 3

I recommend using 2 12V batteries to give you a longer battery life and more amp hours with the TorkLift PowerArmor Solar Locking Battery Box - 6V and 12V Batteries - Diamond Plate Aluminum, #TLA7708RS. When using two batteries, you only need a…

view full answer...

Answer 4

There are 3 different mounting bracket styles depending on how exactly you're wanting to install the Premium Slim LED Strip Light #TN38ZR: - Standard Mount #TN22VR - 45 Degree Mount #TN34ZR - 90 Degree Mount #TN54ZR These different styles will…

view full answer...

Answer 5

The Premium Slim LED Strip Light #TN66ZR can be installed using mounting clips. We have these available in a few different orientations so you'll just need to choose from the following: Flat Mount - #TN22VR 45 Degree Mount - #TN34ZR 90 Degree…

view full answer...

Answer 6

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 7

There should be 2 inches minimum between the tires on a dual axle trailer. This will allow the suspension components room to work properly but a little more room is ideal. For instance the Ultra-Fab Chock and Lock Wheel Stabilizers for Tandem-Axle…

view full answer...

Answer 8

Lippert Carpet Protectors for RVs with Slide Outs #LC134993 do not permanently install though you could leave them where you place them if you want. A slide-out generally slides on 2 rails below the floor of the slide-out room. That is where the most…

view full answer...

Answer 9

If you look at the brackets of the TorkLift HiddenPower Under-Vehicle Battery Mount #TLA7727 you'll see that the top hook goes much wider than the bottom one. There wouldn't be a frame dimension that this will work with since trailer frames…

view full answer...

Answer 10

Yes, you will need the Thule universal change key, #853-1251, to remove and install new lock cores. the change key pulls down all the tumblers so the lock can be removed or inserted. The existing lock, if present, will have to be unlocked for the…

view full answer...

Answer 11

Yes it is; for a 6-gallon tanked RV water heater, there isn't a better option than the Dometic: - Dometic RV Water Heater - Gas and Electric #DMC74FR At 10,000 Btus, this water heater has a higher heating capacity than other units for better…

view full answer...

Answer 12

The direct replacement for your Atwood Gc6aa/10E water heater has been discontinued. I recommend the Atwood RV Water Heater Item #DMC74FR which only requires a 12-3/4" x 12-3/4" cutout. This is a standard gas and electric, 10,000 BTU water…

view full answer...

Does TorkLift PowerArmor Solar Locking Battery Box Need Charge Controller

Product Page this Question was Asked From

Continue Researching