Is There a Drill Adapter Which Is Compatible With 1 Shaft On a Square Trailer Jack?
Question:
Do you make a drill adapter for the 1 inch shaft on a square jack
asked by: Tim M
Expert Reply:
While there is not a drill adapter for the Handle Shaft # TJD-12000-SHABUS on a Square Jack # TJD-12000SP-R2 I do have some ideas for you.
First you can have the handle shaft machined down to accept the Ultra-Fab Speed Socket # UF48-979005. This includes a 12 point 3/4" socket which will also fit a standard 6 point head.
Another option would be to cut the end off a Crank Handle # TJD-12000-HD and weld on a drill end. This means you do not have to modify the shaft on the jack.
Products Referenced in This Question
Replacement Sidewind Crank for etrailer and Ram Square, Direct Weld Jacks - 10,000 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Handles and Cranks
- Sidewind
- etrailer
more information >
Square Jack w/ Crank - Side Pin Drop Leg - Spring Return - 10K Lift - 25-3/4" Travel
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Fifth Wheel Trailer
- Gooseneck Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 9001 - 10000 lbs
- Sidewind Jack
- 26 Inch Lift
- Weld-On
- With Rectangle Foot
- etrailer
more information >
Ultra-Fab Speed Socket Power Drill Adapter for Scissor Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Tools
- Ultra-Fab Products
more information >
Product Page this Question was Asked From
Replacement Handle Shaft for etrailer and Ram Square, Direct Weld Jacks - 10,000 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Handles and Cranks
- Handle Rod
- etrailer
more information >
Continue Researching
- Article: Hard Tonneau Covers vs Soft Tonneau Covers
- Q&A: Does the Galeo Ride GPS Tracking Device for Bikes Come with Everything Needed
- Q&A: Replacement Brass Bushing and Rod for 12,000 lb Fulton Jack
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Q&A: Big Tex Trailer Ramp Replacement Springs
- Q&A: Pairing Instructions for the Galeo Ride GPS Tracking Device for Bikes
- Q&A: Replacement Parts for the Square Direct Weld Jacks
- Q&A: Do 8k Oil Bath End Caps On Lippert Axle Interchange With Dexter End Caps
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Parts for Bulldog Square Jack
- Article: How to Measure for Trailer Hitch Drop
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Wire an Electric Winch
- Article: Trailer Lighting Requirements