How To Tell If Ram Replacement Spring CA-5196-SPR Would Fit Bulldog 2-5/16" Coupler

Question

Question:

will this spring fit a bulldog 2 5/16 coupler?

asked by: Candace

0

Expert Reply:

The # CA-5196-SPR was not designed for a Bulldog 2-5/16" coupler, but measures the 1.68" long and .040" diameter so you can compare that to your current spring to determine if this is going to work for you.

If this won't, just send me over the part number of your coupler and I can try to find the correct replacement for you.

expert reply by: Samuel C

0

Answer 1

From what I was able to find, the Power Gear 522176 was actually the direct replacement for the Power Gear 523983. What I can confirm is that the Lippert 383745 you mentioned is the same motor (just with a different part number) as the 522176, and we…

view full answer...

Answer 2

Although we do not offer that exact replacement fan motor for the Everchill Refrigerators you can use Valterra FridgeCool Automatic Exhaust Fan Item #A10-2618VP which is a universal fit motor and will work with any refrigerator.

view full answer...

Answer 3

The spring part #CA-5196-SPR that you referenced is the spring of the coupler like part #CTA-196 that pushes the parts of the coupler apart when the sleeve is pulled back. I attached a picture that shows a very similar Bulldog coupler. You can see…

view full answer...

Answer 4

According to the Dexter Axle instructions, the bolts that are used to install the E-Z Flex Equalizer for 1-3/4" Double Eye Springs #013-144-03 should be torqued in the range of 30 - 50 ft-lbs (see attached cutout). Attached is an installation…

view full answer...

Answer 5

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 6

Would you be able to tell me what you mean by alternatives or are you looking for the entire assembly?

view full answer...

Answer 7

Basically you will want to compress the spring part #BD500354 so that you can position it in place on your Bulldog Coupler. I attached a picture that shows where the spring installs at. It will just be a matter of compressing the spring to get it in…

view full answer...

How To Tell If Ram Replacement Spring CA-5196-SPR Would Fit Bulldog 2-5/16" Coupler

Product Page this Question was Asked From

Continue Researching