Difference Between Landing Gear Follow Leg Replacements # LC119101 and # LC179014

Question

Question:

WHAT IS THE DIFFERENCE BETWEEN THE LC119101 AND LC179014

asked by: MIKE

0

Expert Reply:

There really isn't a difference between the # LC119101 and # LC179014. One is just listed for Venture landing gear sets and the other Lippert. They are both identical though.

expert reply by: Jameson C

0

Answer 1

There is a great chance either of the legs you mentioned would work as a replacement, but I'd need to know for sure what landing gear you have on your trailer. The Lippert landing gear like the part #LC179013 and #LC179014 are very popular and…

view full answer...

Answer 2

I went out to the warehouse to measure replacement gear box #LC276602. From the base of the gear box to the end of the shaft on the output side it is 4.75 inches. From the end of the shaft to the center of the pin is 1.35 inches. The diameter of the…

view full answer...

Answer 3

For your Venture landing gear you can use #LC276602 that you referenced as it is a confirmed fit.

view full answer...

Answer 4

Yes, based on the picture you sent in the replacement gearbox part #LC276602 that you referenced is the correct replacement. This is aluminum too which means it will be a bit stronger as well.

view full answer...

Answer 5

Since the gearbox was damaged, you are going to need to replace the entire gearbox itself. We have exactly what you need for your Venture landing gear, which is the Replacement Gearbox for Venture Aluminum Electric 5th Wheel RV Landing Gear…

view full answer...

Answer 6

Yes the gear box part #LC276602 does work with the motor you are getting part #LC196308. This motor and gear box design is very common and there is a lot of overlap between part numbers that fit both.

view full answer...

Answer 7

It's probably time for a new motor and gear box like you suspected. The part #LC276602 that you referenced is the correct gear box and then for a motor #LC196308 and you'd be set.

view full answer...

Answer 8

We have just what you need to replace your landing gear motor M9000PK with the #LC196308 and you'd be set! This is a confirmed fit for what you have and is a faster motor too so your jacks will raise and lower quicker.

view full answer...

Answer 9

From what I have found, your old motor was the M-9000 motor gearbox used on the LGS-9000 landing gear. The Lippert Components Tuson High Speed 5th Wheel RV Landing Gear Motor #LC141893 has the same dimensions and will work as a replacement. This…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Difference Between Landing Gear Follow Leg Replacements # LC119101 and # LC179014

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching