Does the 2-Speed Boat Trailer Winch with 20' Strap and Brake Come with Mounting Hardware

Question

Question:

does this come with the mounting hardware?

asked by: Thomas P

1

Helpful Expert Reply:

The 2-Speed Boat Trailer Winch with 20' Strap and Brake # 315-W3200D does not come with mounting hardware. This is the case with all of our winches.

expert reply by: Jon G

1

Answer 1

The 3,200 lb 2-Speed Boat Trailer Winch with 20' Strap and Brake #315-W3200D will be sufficient to pull in your 3,190 lb boat if your trailer has rollers on it as that will make your boat easier to move. If you have bunks then it will…

view full answer...

Answer 2

The Replacement Handle for Dutton-Lainson Single Speed Hand Winch #DL70305 mounts to the same size shaft that is on the 2-Speed Boat Trailer Winch #315-W3200D. This will give you a 7" long handle like the previous handle you had on your other…

view full answer...

Answer 3

The 2-Speed Boat Trailer Winch part #315-W3200D is an excellent upgraded 3,200 lb winch for a boat trailer. In regards to mounting, not all winches use the same pattern so you'd need to compare the dimensions in the photo below to what you have…

view full answer...

Answer 4

I spoke with my contact at BoatBuckle regarding the difference in break strength between the G2 Ratchet Tie-Downs in Stainless Steel #IMF14256 and the Standard #IMF08893. He said the main reason the stainless steel model has a lower break strength of…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

I definitely understand how safety chain capacities and determining exactly what chain rating you need for your trailer can be a bit confusing. To keep it as simple as possible, safety chain requirements state that the breaking strength of EACH…

view full answer...

Answer 9

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Does the 2-Speed Boat Trailer Winch with 20' Strap and Brake Come with Mounting Hardware

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching