Will etrailer Hitch Mounted Spare Tire Carrier Mount 215/85R16 Tire

Question

Question:

I want to use the hitch mount e98ZR to mount a spare using the receiver hitch on my Jayco Melborne 24foot class C RV, on a MB Sprinter Chassis. The tire size is LT 215/85R16. Will this hitch mount work?

asked by: LaMont A

1

Helpful Expert Reply:

Yep, your 215/85R16 spare tire is 100 percent compatible with the etrailer Hitch Mounted Spare Tire Carrier # e98ZR.

expert reply by: Kyle S

1

Answer 1

I recommend the Roadmaster Spare Tire Carrier #RM-195125 for your 2021 Winnebago Solis Class B motorhome on the Ram ProMaster 3500 Chassis. Since you have the doors on the back of your Solis the Roadmaster carrier will allow for you to easily move…

view full answer...

Answer 2

You can use the etrailer hitch mounted spare carrier part #e98ZR in the front hitch of your 2019 Ford F-350 and it will work just fine. It can carry a dually wheel as well. It doesn't have a stated weight capacity but it can carry a heavy dually…

view full answer...

Answer 3

Yes the Brophy Rigid Mount Spare Tire Carrier #BR56VR that you referenced would fit your bumper that is 4 inch square, has enough weight capacity, and can work with your bolt pattern.

view full answer...

Answer 4

The Brophy Rigid Mount Spare Tire Carrier for 4 inch or 4-1/2 inch RV or Mini-Motorhome Bumpers #BR56VR per Bropy states that from the top lug bolt down to the top of the U-bolt is 6-1/2 inches.

view full answer...

Answer 5

The etrailer Hitch Mounted Spare Tire Carrier - 2" Hitch #e98ZR will work perfectly with your 225/75R16 tire/wheels. This is a pretty simple application but we do include an adjustable stop collar to make it easier to line up your hitch pin…

view full answer...

Answer 6

The etrailer Hitch Mounted Spare Tire Carrier #e98ZR that you referenced does not have a stated weight capacity but it would easily handle the weight of an 80 lb wheel and tire in the size of 245/70-19.5 so it would work well for you.

view full answer...

Answer 7

The standoff tab on the Brophy Rigid Mount Spare Tire Carrier part #BR56VR is about 5" so as long as the width of the tire does not exceed 10" (0 offset wheel) you should be able to mount the wheel either way. If the width of the tire…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 12

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Will etrailer Hitch Mounted Spare Tire Carrier Mount 215/85R16 Tire

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching