Recommended Wheel Center Cap for Keystone RV with 16" 8 Lug Wheels

Question

Question:

Need wheel center caps for 16” wheel. 2013 keystone Rv 5th wheel 8 lug

asked by: Mike

0

Expert Reply:

It looks like most of our 16" trailer wheels with a 8 on 6-1/2" bolt pattern have a 4.88" or 4.9" pilot hole. If that is what you have then you can use the Lionshead Trailer Wheel Center Cap part # LHCS109-SI60C. Please note, we have no way to look up what exact wheels you have on your trailer so if you're looking for a specific style of center cap we would need a photo to assist further.

expert reply by: Conner L

0

Answer 1

Though The Lionshead Trailer Wheel Center Cap #LHCS108 will not work for you because it has a 4.25 inch pilot hole The Lionshead Trailer Wheel Center Cap w/ Snap-In Plug #LHCS102-SI60C will work for you. The Lionhead center cap #LHCS102-SI60C has a…

view full answer...

Answer 2

Currently the Replacement Center Cap #NA9130 is the only part that is separate from the Namsco Wheel Liners #NA226H40N for your Workhorse Chassis.

view full answer...

Answer 3

Thanks for all the information! I was able to check out your Kaper II A-C-490TT that you're needing a replacement center cap plug for, and the closest center cap plug I was able to find is the Trailer Wheel Center Cap Plug #CCP-60C, which…

view full answer...

Answer 4

The trailer wheel part #LH39FR that you referenced would work great on a Dexter 7,000 lb trailer axle. Thankfully basically all trailer wheels have a zero offset so unlike on vehicles that require picking out the correct backspacing with trailer…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 10

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 11

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 12

Good morning, Cliff. As of today (3/27/24) we are expecting the #KE33JR tire/wheel combo to be in stock in about 2 weeks. Hopefully this means we can take our own pictures and put them on the site within maybe about 3-4 weeks from now. What I can…

view full answer...

Recommended Wheel Center Cap for Keystone RV with 16" 8 Lug Wheels

Product Page this Question was Asked From

Continue Researching