Are There Any Manual Changeover Dual Tank Propane Regulators Available

Question

Question:

I would like to connect two 20 lb propane tanks using solely for grilling with a manual change over valve - so when the in use tank goes empty I can switch over to the full tank and later remove the empty tank for refilling. I don’t want an auto switching regulator since I will be right there, to do the switch, when the in use tank goes empty. I assume my current regulator will need to be replaced unless some type of fitting is available to connect it to a manual changeover valve. Do you have anything like this? Many Thanks

asked by: Joseph P

0

Expert Reply:

Since we don't currently have a manual changeover regulator the easiest option to essentially make it manual would be to simply use a automatic one like the MB Sturgis High Capacity Two-Stage Auto Changeover Regulator # 888001-MBS you were looking at and just simply open only one propane tank valve at a time.

You could run both tanks to a manifold with separate cutoff valves and then to a single tank regulator like you most likely have, but you'd be adding additional components, taking up space and adding more failure points for a leak.

If you don't already have a dual tank setup then you'll most likely need a new holder. For 20lb tanks you can use part # 37220BL and for 30lb tanks you can use part # 37230B. If you'd like a cover for both tanks then you can use part # CAM40542 to protect them and help prevent any corrosion to the regulator or hoses/fittings. You'll also want to pick up some pigtail hoses to connect to the regulator like part # 100575-15-MBS.

expert reply by: Kevin C

0

Answer 1

Yes it is super simple! The Complete Propane Tank Holder Mounting Kit for 20-lb Tanks part #37220BL is secured to the tongue of the trailer using self tapping screws. #14 self tappers have always worked out really well and they will go into the three…

view full answer...

Answer 2

Yes, we have the correct replacement leader hose that attaches your tank to the regulator. For this you are going to want to use the MB Sturgis Sturgi-Stay Propane Fill Hose part #100019-24 for 2' long, part #100019-36 for 3' long, part…

view full answer...

Answer 3

Yes, the #100019-24 pigtail can be used to connect your dual-cylinder 100 lb propane setup to the regulator on your RV. Since this hose does not have a back-check to contain a gas leak, you will need the #204120-MBS fitting that includes a…

view full answer...

Answer 4

The only pin that should be continuously showing 12V power on the 7-Way connector on your vehicle is the 12V power circuit which is normally the black wire but not always. In 7-way wiring the 12V auxiliary power feed is carried on the contact at the…

view full answer...

Answer 5

To add a 100 lb tank to your two 30 lb tanks, I recommend the MB Sturgis Sturgi-Stay T-Fitting w Hose - Type 1 Valve - Quick Disconnect, Disposable Cylinder Ports #103615. This will allow you to connect the red fitting to one of your tanks and the…

view full answer...

Answer 6

To add a 100 lb tank to your two tanks, I recommend the MB Sturgis Sturgi-Stay T-Fitting w Hose - Type 1 Valve - Quick Disconnect, Disposable Cylinder Ports #103615. This will allow you to connect the red fitting to one of your tanks and the pigtail…

view full answer...

Answer 7

If you want to increase the load range for the tires to help prevent another blow out then you can definitely switch out to load range H. We currently only offer a load range G in this size #PRG80235. If you switch to 235/85R16 then you'd be…

view full answer...