Will the Atwood RV Carbon Monoxide and Propane Gas Detector # AT36681 Replace an Atwood 36636

Question

Question:

I need to replace my LPCO detector. The one I currently have is P/N#36636. Is #36681 the same, just a newer version?

asked by: Missy S

0

Expert Reply:

I can tell you for sure that the Atwood RV Carbon Monoxide and Propane Gas Detector # AT36681 will work great to replace your current Atwood 36636 detector.

From what I was able to find on your current Atwood 36636, the Atwood RV Carbon Monoxide and Propane Gas Detector # AT36681 does look to be basically the same detector, just a newer version.

expert reply by: Scott S

0

Answer 1

Yes, the 2-Wire RV Propane Gas and Carbon Monoxide Detector, #RS54FR has two different mounting brackets to select from allowing coverage of the existing hole from previous installs. Please note the attached product review video.

view full answer...

Answer 2

We have a couple of options to replace your Atwood 36636, and you can use either. One is from Atwood and the other from RV Safe: - Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 - RV Propane Gas and Carbon Monoxide Detector - Black…

view full answer...

Answer 3

It's a very smart idea to replace your out-of-date ProTECHtor Series 2001 and the Atwood RV Carbon Monoxide and Propane Gas Detector - 12 Volt - White #AT36681 is the perfect option for a replacement. In regards to a fit, based on my research the…

view full answer...

Answer 4

The instructions state the rest/test button of the Atwood RV Carbon Monoxide and Propane Gas Detector - 12 Volt - White #AT36681 is the button on the top right, and you need to press that in and hold it down. If the rest does not work and the red…

view full answer...

Answer 5

Since you have an Atwood detector you could simply replace it with the Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 that you were looking at, which I HIGHLY recommend for your safety. These detectors are wired to your DC distribution…

view full answer...

Answer 6

We've seen this issue before on your Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 and the beeping every 40 seconds indicates "a fault has been detected that compromises some detector function." What you need to do is use…

view full answer...

Answer 7

The Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 is a really great option. It runs off of 12V power and comes with the option to wire it to a second power source in the event that the first power source fails (as in the main battery…

view full answer...

Answer 8

On the top of the Atwood Carbon Monoxide detector part #AT36681 there are two tabs you need to depress to pry the bezel off the front of it which will then show you the screws/hardware that secure the detector to your wall.

view full answer...

Answer 9

You can use the RV Propane Gas Detector #RS64FR to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 10

The Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 does have two power wires which one of them gets ran to the main power source and the other a backup battery. I would verify for sure that you have power to the wire you have ran…

view full answer...

Answer 11

The Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 has three wires though you only need to use two of them - a red for power and black for ground. The other red wire is for an optional back-up power source which is not necessary for…

view full answer...

Answer 12

The red blinking light on the Atwood RV Carbon Monoxide and Propane Gas Detector part #AT36681 under the propane heading means that the propane sensor is disabled or faulty. I recommend doing a hard reset of the unit but if that does not work then…

view full answer...

Will the Atwood RV Carbon Monoxide and Propane Gas Detector # AT36681 Replace an Atwood 36636

Continue Researching