Does Lippert Tandem Axle Equa-Flex AP Kit Have Extra Wet Bolts

Question

Question:

I have a 2019 GD Solitude 2930RL. It looks as though this kit has four extra wet bolts. Is that correct or am I missing something? I need the four shackle bolts and two additional wet bolts for my current Equaflex set up.

asked by: Michael L

0

Expert Reply:

There are not extra wet bolts with the Lippert Tandem Axle Equa-Flex AP Kit # LC64FR.

Three are for hanging the leaf springs and equalizer one one side, and the other three will be for the other side. If your leaf springs don't attach to hangers with wet bolts you can replace the nylon bushings in the springs with Bronze Bushings # K71-291-00 and use the wet bolts that come with this kit, or you can not use those wet bolts and just use standard Shackle Bolt # 166081.

expert reply by: Kyle S

0

Answer 1

A leaf spring should be replaced if it is badly rusted, has cracks or breaks in its leaves or if it is sagging. A 14-year-old travel trailer could certainly be in need of new leaf springs. The keys to selecting correct replacement leaf springs are to…

view full answer...

Answer 2

It does sound like you have found some clear damage to your 5th wheel trailer's leaf springs that will require attention. Uneven tire wear can be caused by a number of things - incorrect pressure, inadequate weight on the axle or a visibly…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

To correctly measure a leaf spring, you'll want to jack the trailer up on jack stands so the axle is hanging freely, then measure directly across from the center of one spring eye to the other, as shown in the provided diagram. The height of the…

view full answer...

Answer 6

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 7

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…

view full answer...

Answer 10

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is the…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Does Lippert Tandem Axle Equa-Flex AP Kit Have Extra Wet Bolts

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching