Availability of Replacement Rear Jack Leg For Lippert 2.0 Electric Leveling System

Question

Question:

Is it possible to get just the leg for the rear jack on a lippert 2.0 leveling system

asked by: Don E

0

Expert Reply:

Yes, the Replacement Heavy-Duty Landing Gear Jack Leg # LC241844 will replace a rear leg for your Lippert 2.0 electric leveling system.

expert reply by: Bud M

0

Answer 1

I have an answer for you. Unfortunately, we do not sell replacement components you need as a complete set. They have to be purchased individually. Although, we do carry all those parts. Here are the replacements you need: - Replacement Heavy-Duty…

view full answer...

Answer 2

I sent your picture to my tech contact at Lippert and they responded with saying that the mounting brackets are designed to go behind and under the cross shaft of the slide out. If you check out the picture I attached you'll see how it would fit…

view full answer...

Answer 3

We absolutely carry replacement gears like the Lippert Venture Follow Leg Repair Kit for 5th Wheel RV Landing Gear #LC146060 which will work with Lippert Components powered landing gears, which is the most common landing gear used however you'll…

view full answer...

Answer 4

Thank you for the photo of your trailer landing gear interior. We can help you with a repair kit for the lead and follower legs of your Venture landing gear. For a lead leg repair kit use #LC146059 and for the follow leg use kit #LC146060. It is hard…

view full answer...

Answer 5

To replace just the drive shaft you will need part #LC146059 for the lead leg and part #LC146060 for the follow leg on your Venture landing gear.

view full answer...

Answer 6

The landing gear looks like a standard set based on the pictures and the dimensions you listed. The part #LC146060 would be what you need for the follow leg and then part #LC146059 for the lead leg.

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Availability of Replacement Rear Jack Leg For Lippert 2.0 Electric Leveling System

Product Page this Question was Asked From

Continue Researching