Can Curt A30 Fifth Wheel Hitch Be Used with Sidewinder Pin Box

Question

Question:

Can you use a sidewinder with this hitch?

asked by: Dan K

0

Expert Reply:

If the Sidewinder is a first generation Sidewinder then yes you can use the Curt A Series fifth wheel hitches like the A30 part # C64BR but if it's a second gen it won't work. But Sidewinder found was that the wedges were getting sheared off with this hitch and the second gen models.

expert reply by: Jameson C

0

Answer 1

Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY58GR that you referenced.

view full answer...

Answer 2

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 3

Hey Jeff, appreciate all the details you provided that was super helpful and we do have the MORryde cushioned pin box that is designed to replace a Lippert Rhino pin box. For the 17,695 lb GVWR you mentioned on the 2024 Brinkley Model Z 3610, what…

view full answer...

Answer 4

The Curt A25 5th Wheel Trailer Hitch for Ram Towing Prep Package #C16046 will work well with the Roto-Flex pin box. The combination will be a good match for you and this hitch with the specific connection to the factory prep package pucks will make…

view full answer...

Answer 5

The Access Toolbox Edition Soft, Roll-Up Tonneau Cover #A93VR is designed to fit the youru 2022 Ram 3500 with a 8' dually bed. The Cover #A37FR will only fit an 8' bed with single rear wheels. This is the only difference in these covers is…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

As long as the RBW Lil' Rocker mounts to industry standard base rails you'll need the Curt Adapter Rails #C29BR that fit in the OEM puck system on your 2019 Ram 2500 and give you a standard base rail connection. I'm attaching a photo…

view full answer...

Answer 8

If you have the Gooseneck versions of the Curt CrossWing ( #C92DR or #C32DR) you unfortunately would not be able to use the Rota-Flex with it. The pivoting head causing too much strain for the single point of contact you have with a gooseneck hitch.…

view full answer...

Answer 9

The Go Power Solar Flex Eclipse Charging System w/ MPPT Solar Controller and 190 Watt Solar Panel #GP67MR is perfectly safe to install directly on your RV roof. You're correct that the flat "fixed" solar panels are designed to have some…

view full answer...

Answer 10

Most standard pin boxes will not make a 90 degree turn in anything less than an 8 foot truck bed, but that is due to being too close to the cab - not the rails. You mentioned you wanted to replace the Rota-Flex with the Gen-Y hitch. Your old pin box…

view full answer...

Answer 11

As long as your 2022 Ram 3500 doesn't have the factory air suspension I recommend the Air Lift LoadLifter 5000 Ultimate Air Helper Springs #AL88231. Since these are adjustable with the air pressure you can better dial in your ride height. They…

view full answer...

Answer 12

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Can Curt A30 Fifth Wheel Hitch Be Used with Sidewinder Pin Box

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching