Can The 7/8" Bumper Adapter Pins Be Used With The 1" Blue-Ox Off-Road Bumper Adapter?

Question

Question:

Have poison spyder frt bumper on my Jeep. Ordered the 1” adapter tab is 1” wide hole dia. Is 7/8” can 7/8” pins be used with the 1” adapter

asked by: Dwiliiams

0

Expert Reply:

For your Blue Ox Off-Road Bumper Adapters for Blue Ox Motorhome Mounted Tow Bars # BX88358 you're actually going to want to use the Replacement 1" Pins and Spacers for Blue Ox Off-Road Bumper Adapters # BLU83XR instead of the Replacement 7/8" Pins and Spacers for Blue Ox Off-Road Bumper Adapters # BLU73XR you're inquiring about.

Reason being, you're going to want as minimal amount of play in those pins as possible, so using the corresponding 1" pin is going to be the best solution.

Attached are a couple of videos for you to check out as well.

expert reply by: Bryce D

0

Answer 1

For your 2021 Jeep Wrangler Unlimited, there is not yet a confirmed fit front mounted hitch receiver for you to utilize with a plow from any of our manufacturers. Even if there was, that wouldn't allow you to flat tow 4 down with and you would…

view full answer...

Answer 2

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 3

Unfortunately there are no plug-in adapters or harnesses that would allow you to replace the factory 4-way flat trailer connector with a 7-way or a 7-way and 4-way connector on your 2005 Ford F-150. To complete the installation for a brake controller…

view full answer...

Answer 4

Actually our etrailer.com brand brake assemblies are rebranded AxleTek assemblies. So we have the 8k left and right assembly set #AKEBRK-8 which is most likely what you need but these are 12-1/4 inch in diameter by 3-3/8 inches wide and attach with a…

view full answer...

Answer 5

The most similar trailer clearance lights we offer to replace the PM150 lights you have now would be the Thinline LED light part #AL91RB. For a replacement harness that would plug into this you'd need the part #A46PB and then for a grmmet part…

view full answer...

Answer 6

The Tow Ready wiring harness #118571 is rated for 7.5 amps for brake lights and turn signals and 7.5 amps total for running lights. The fuse that goes on the power wire connection to the battery is a 10 amp fuse. The wire gauge of the long 12 volt…

view full answer...

Answer 7

Most likely the new axle has self-adjusting brakes which when new are known for feeling pretty weak. The good news is that you can keep applying them over and over while the trailer is traveling and they will tighten and get more sensitive feeling.

view full answer...

Answer 8

If you think the cause for the noise on your 2015 Jayco Whitehawk 24RBS tandem-axle travel trailer is from the normal travel of the suspension components (leaf springs, equalizers and shackle straps), you might switch over to wet bolts. The squeaking…

view full answer...

Can The 7/8" Bumper Adapter Pins Be Used With The 1" Blue-Ox Off-Road Bumper Adapter?

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching