Can Progressive Dynamics Transfer Switch Quick Flip Connectors Be Wired for Dominate Shore Power

Question

Question:

Can this transfer switch be wired so shore power is dominant and inverter is backup. Want to use for sump pump backup in home. When grid fails want the inverter to kick on automatically and when grid power comes back on want to switch back to grid automatically

asked by: Jeff

1

Helpful Expert Reply:

I reached out to Progressive Dynamics for you about the Progressive Dynamics Transfer Switch with Quick Flip Connectors part # PD5110010Q and they responded as follows:

"I was able to make this work on our test bench. You would want to jumper the H1-H2 connection to disable the time delay. The jumper is shown in the attached owners manual. These are the .10 inch jumpers often used on PCB boards. Then attach the dominant line to the Generator connections and the inverter line to the power cord connection . This allows either line to be on at all times."

expert reply by: Conner L

1

Answer 1

Yes, you can use the Progressive Dynamics Transfer Switch with Quick Flip Connectors #PD5110010Q to connect two power sources (shore power and generator/inverter) but only one can be used at a time. It will automatically switch your AC input from…

view full answer...

Answer 2

My recommendation is to simply unplug from the power pedestal if you wish to start up the generator for a maintenance run. It is the safest way to ensure that you do not overload your electrical system. Please ensure you follow the installation…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

For your 2023 Coachmen Pursuit 31BH you will need the Front SumoSprings Rebel Custom Helper Springs #SSF-170-40-2 and Rear SumoSprings Maxim Custom Helper Springs #SSR-184-40-1. If you were to select only one to install first I recommend the rear…

view full answer...

Answer 6

For your 2024 Ford F-53, I recommend checking out the Timbren Front Suspension Enhancement System #TFFF53B for the front, and the Timbren Rear Suspension Enhancement System #TFRF53A for the rear. These kits do not require drilling, will replace your…

view full answer...

Answer 7

Your transfer switch can still be used since it's just selecting the power source that's going to run to the Progressive Dynamics #PD4135K. If you ever have issues with it later on you can replace it with Progressive Dynamics #PD5110010Q.

view full answer...

Answer 8

Since the part #PD4655V has come out and has ability to switch between lithium and lead acid batteries the part PD4655LIV was discontinued. At one point there were separate parts for lithium and lead acid batteries but since the current one can do…

view full answer...

Answer 9

The Progressive Dynamics Replacement Section #PD4655V does have a jumper to change the charging profile to lithium compatible. You'll simply need to move the black jumper over from the WIZ side to the LI side.

view full answer...

Answer 10

To convert the WFCO WF-8955PEC to be lithium compatible you'd need the part #PD4655V and you'd be set. This fits in the panel without any modifications.

view full answer...

Answer 11

From what I could find, the Victory Components Model 7355 will be the same as a Parallax model 7355. The Progressive Dynamics Replacement Converter #PD4655V will be a replacement for this and is also made in the USA. It should be noted that this will…

view full answer...

Answer 12

According to my contact at Progressive Dynamics, when installing the #PD4655V replacement converter it's not necessary to replace the DC board, as your current one is still working. However, it wouldn't be the worst idea in the world to go…

view full answer...

Can Progressive Dynamics Transfer Switch Quick Flip Connectors Be Wired for Dominate Shore Power

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching