What Size is the Opening On the Mounting Clip # Y8881252 For Holding a Water Hose?

Question

Question:

What are the dimensions of the clip? I want to use these on my DYI water set up. The hose Im using is 7/8 OD.

asked by: Chad

0

Expert Reply:

The Replacement Hose Mounting Clip # Y8881252 is 13/16" inside diameter for holding the hose. We offer the Velcro Hose Strap # Y8881254 which will provide a more secure mounting point for your 7/8" hose if this is something that will be installed on a vehicle or trailer.

expert reply by: Bud M

0

Answer 1

Yes, the Bright Way Deep Cycle RV or Marine Battery #BRW94FR is a great battery for using with a trolling motor on a boat. The battery is sealed as it is an AGM battery so there is no acid that may leak. The battery is rated for 100 Amp Hours so you…

view full answer...

Answer 2

There are 2 ways to fill the Yakima RoadShower Portable Solar Shower #Y79VR with water. If you have a pressurized water source you can use the included quick connect to attach a hose allowing you to fill the tank from the same port you attach the…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

What Size is the Opening On the Mounting Clip # Y8881252 For Holding a Water Hose?

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching