Why Does Redarc Industrial Pure Sine Wave Inverter Have an Ethernet Connection

Question

Question:

What is that Ethernet connection for? It seems weird to have that on a power unit like this.

asked by: Milton

0

Expert Reply:

Great question!

The RJ45 - more commonly known as Ethernet - port on the Redarc Industrial Pure Sine Wave Inverter # RED35RR is for connecting this to the Remote # RED95RR or the RedVision Vehicle Management System # RED89FR.

Redarc likes to use the Ethernet connection for this type of stuff because it's common to find so easily replaceable if need be, and they don't have to reinvent the wheel just to make their products work. You'll find this type of connection woven throughout a lot of their electrical products, including their trailer brake controllers!

Attached are some review videos and installation instructions for you to check out!

expert reply by: Jon G

0

Answer 1

Hey Steven, the Go Power Solar Panel kit part #GP66FR that you referenced does come with the correct 2-pin XLR style of plug that your Furrion solar charge input uses so it will work fine without needing an adapter. This comes with a few connector…

view full answer...

Answer 2

We have just what you need, the Go Power Portable Solar Panel with Digital Solar Controller, #34282610. This lets you place the solar panel where you need it for maximum sunlight while not having to place the camper in the sun too. For the later…

view full answer...

Answer 3

For a 3,000 watt inverter like the #34275013 it's recommended to use 1 or 0 AWG between it and the panel. Solid or stranded is fine.

view full answer...

Answer 4

The Go Power Industrial Pure Sine Wave Inverter Charger #34275013 has an automatic transfer switch built into it so since you are wanting a simpler setup this would be a great solution for you. This is a 3 in 1 unit that combines an inverter, a…

view full answer...

Answer 5

I sure can; I have added a photo for you with the dimensions of the mounting hole for the 50 amp SmartPlug inlet and connector. This comes in your choice of three different colors, and the dimensions are the same for each: - Black: SmartPlug RV Power…

view full answer...

Answer 6

I've linked you to the installation instruction for the Rampage LED Tailgate Light Bar. The light bar features a 4-pole flat trailer connector that would plug into the existing 4 pole trailer connector on the vehicle. The wiring harness has an…

view full answer...

Answer 7

An RV air conditioner system is going to pull roughly 100 amps per hour so you wouldn't be able to run it long enough with your current battery bank. RV solar unfortunately isn't at a point where it would replenish the battery bank fast…

view full answer...

Answer 8

We actually have had customers make the swap from rubber valve stems to metal valve stems so they can use the TST TPMS for RVs - Color Display - Signal Booster - 4 Flow Through Tire Sensors #TST-507-FT-4-C. I added the cut out of that review for you…

view full answer...

Answer 9

The power draw of the MaxxFan Deluxe Roof Vent w/ 12V Fan, Thermostat, and Remote #MA00-07000K is 5 amps at 12 volts.

view full answer...

Answer 10

Most if not all trailer wiring harnesses/connectors use larger wires for the 12 volt and ground circuits compared to the other circuits (lights). The sockets themselves don't have an amperage rating so you will go by the draw of the things…

view full answer...

Why Does Redarc Industrial Pure Sine Wave Inverter Have an Ethernet Connection

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching