Replacement Slide-Out Motor For a Power Gear 13-1119 Slide-Out Motor

Question

Question:

i have a 2004 damon intruter 373 and i need a living room slide ...my old part number is 13-1119 .k01265p500...do you have a replacement

asked by: Michael

0

Expert Reply:

From what I could find given the part number you provided. It comes back to a Power Gear slide-out motor. The correct replacement slide-out motor for a Power Gear 13-1119 is the Replacement Gear Motor Assembly for Lippert Electric Slide-Out # LC386322.

expert reply by: Scott S

0

Answer 1

If your 2003 Fleetwood Prowler 27 has a Power Gear slide out motor 421292, then you could use the Lippert #LC387738. Otherwise I would need to know what model number is on the motor you currently have to see if we can locate an acceptable…

view full answer...

Answer 2

I checked with Lippert, and the torque is 400 in-lbs at 15 amps for the slide-out motor you asked about, which is the following part number: - Replacement Gear Motor Assembly for Lippert Electric Slide-Out #LC386322

view full answer...

Answer 3

Per Lippert, the motor you listed, part number 13-1119 can be replaced with the Replacement Gear Motor Assembly for Lippert Electric Slide-Out #LC386322.

view full answer...

Answer 4

The physical difference is that the #LC386322 has a connector on it and the part #LC387738 has two blunt cut wires that would need to be spliced. They are the same thing aside from that. One is just intended for the Lippert brand and the other Power…

view full answer...

Answer 5

Based on the number you mentioned the correct replacement motor is the part #LC386322.

view full answer...

Answer 6

From the research I have done, I believe the slide out on your Northwood Arctic Fox Travel Trailer uses Replacement Gear Motor Assembly for Lippert Electric Slide-Out, #LC386322.

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 11

To replace the motor on the LCI Pump 650057 we have the Replacement Motor #LC167576.

view full answer...

Answer 12

I spoke with Lippert and found that their replacement for your PowerGear Slide Out Motor 13-1086 is the Replacement Gear Motor Assembly for Lippert Slide-Out #LC386321.

view full answer...

Replacement Slide-Out Motor For a Power Gear 13-1119 Slide-Out Motor

Product Page this Question was Asked From

Continue Researching