Correct Replacement Sink For A LaSalle Bristol Sink

Question

Question:

I want to replace bath sink, old unit is a LaSalle Bristol product. A label on this unit has a # 156 circled. Question, is this the same item as your item # 34416156PPA? Thanks

asked by: Henry B

0

Expert Reply:

I went ahead and checked out your LaSalle Bristol bathroom sink 156 and it appears that the:

-LaSalle Bristol Single Bowl RV Bathroom Sink # 34416156PPA you mention is the same product.

This sink measures 13-3/4" long x 10-3/8" wide x 6-3/4" deep, has an interior measurement of 11-1/2" long x 8-1/8" wide x 6" deep, and has a drain hole diameter of 1-1/8".

expert reply by: Bryce D

0

Answer 1

The black tube in the attached picture is meant to be attached to the bottom of the LaSalle Bristol Single Bowl RV Bathroom Sink part #34416156PPA. At that point you can use the flex pipe in your RV to connect directly to the black pipe. The flex…

view full answer...

Answer 2

When gluing together Valterra RV sewer pipes like the #T1028 you'd need to use an ABS solvent cement like the part #A05-0303.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 6

The torque for the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles - 12" - 5 Spoke Utility #8-174-5UC3 is not specified by the manufacturer. For 9/16 inch studs, the typical lug nut torque will be 120-140 ft lbs based on most…

view full answer...

Answer 7

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Correct Replacement Sink For A LaSalle Bristol Sink

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching