Recommended Replacement For A Progressive Dynamics PDPD5110010 Transfer Switch

Question

Question:

I currently have PD5110010, with no letter at the end. I am needing a replacement and not sure what I need.

asked by: Terri L

1

Helpful Expert Reply:

The Progressive Dynamics Transfer Switch with Quick Flip Connectors # PD5110010Q you were looking at is the correct replacement for a PD5110010 Transfer Switch. It comes with quick flip connectors to make installation easy peasy. I've attached a picture of the wiring diagram below to help you with this process.

expert reply by: Kevin C

1

PD5110010Q Wiring Diagram
(click to enlarge)

Answer 1

The Go Power Industrial Pure Sine Wave Inverter and Inverter Charger #34275013 will output on both sides when inverting. With the inverter you would only have about 25 amps total output but that is split between both of the legs. From shore or…

view full answer...

Answer 2

Yes. You can replace the Progressive Dynamics PD4590K18NS2 with the Replacement Converter Section for Progressive Dynamics 4500 Series RV Power Control Center - 90 Amp #PD4590CSV without any issues. Both are 90 amp converters from the same Series…

view full answer...

Answer 3

I contacted our Go-Power Rep for this question to ensure we provided you best possible response about the Go Power Automatic Transfer Switch, #34270278. After explaining your question they stated that conceptually this should work the way you are…

view full answer...

Answer 4

The MORryde RV Generator Slide Out Tray #MR89RR that you referenced has specific instructions from MORryde that you can't operate a generator when it is sitting on the tray. Even if it was locked in out position.

view full answer...

Answer 5

The MORryde RV Generator Slide Out Tray part #MR89RR weighs 32 lbs total.

view full answer...

Answer 6

I spoke with the manufacturer to ensure the measurements were correct and found that the chart on the page for #LC432690 is incorrect. It does require 27-1/2" of space for the mounting brackets. Both the #LC432690 and #LC432696 will be too big…

view full answer...

Answer 7

Since the part #PD4655V has come out and has ability to switch between lithium and lead acid batteries the part PD4655LIV was discontinued. At one point there were separate parts for lithium and lead acid batteries but since the current one can do…

view full answer...

Answer 8

Your transfer switch can still be used since it's just selecting the power source that's going to run to the Progressive Dynamics #PD4135K. If you ever have issues with it later on you can replace it with Progressive Dynamics #PD5110010Q.

view full answer...

Answer 9

The Progressive Dynamics Replacement Section #PD4655V does have a jumper to change the charging profile to lithium compatible. You'll simply need to move the black jumper over from the WIZ side to the LI side.

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Recommended Replacement For A Progressive Dynamics PDPD5110010 Transfer Switch

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching