How to Determine the Correct Entry Steps For a 2021 Luck Element Vinos Cargo Trailer

Question

Question:

I have a 2021 luck element Vinos 17 foot cargo trailer that I have customized. I want to get steps for it and had previously gotten some that did not fit very well as the trailer is low to the ground. Can you please give me the best step to get for that particular model?

asked by: Adam K

0

Expert Reply:

A step like the TorkLift GlowStep Camper Scissor Steps # TLA7802 will be the best option that we have. There is not any sort of database or anything that tells us the correct steps for cargo trailers or RV's. You would need to know your entry height and width.

For instance the TorkLift GlowStep Camper Scissor Steps # TLA7802 fits an entry height of 16" - 23" which is the lowest we have and a width of 20".

expert reply by: Scott S

0

Answer 1

When folded up into the stored position the TorkLift GlowStep Camper Scissor Steps #TLA7802 are approximately 9-1/2" deep. I confirmed with TorkLift that this specific model is designed to just fold up, lock in place and be ready to travel.

view full answer...

Answer 2

I attached a picture of a similar set of the TorkLift GlowStep Scissor Steps as the part #TLA7802 that you referenced in the stowed position.

view full answer...

Answer 3

It's hard to say exactly how stable the step setup would be, but the TorkLift GlowStep Camper Scissor Steps #TLA7803-8000 that you referenced could have it's bracket attached to the bottom step of your current steps to bridge the 30…

view full answer...

Answer 4

The TorkLift GlowStep Camper Scissor Steps #TLA7802 weigh 16 lbs.

view full answer...

Answer 5

We do not have a 20" wide quick attach model of step similar to the TorkLift GlowStep Camper Scissor Steps #TLA7802. The closest we have to 20" wide that are detachable are the Brophy Camper Scissor Steps #SS02 which are 17" wide.

view full answer...

Answer 6

The install and removal of the step portion of the GlowSteps part #TLA7802 is pretty easy and does not require the use of any tools. Basically you just pull out cotter pin and then slide the pin out and you can remove the steps from the bracket. No…

view full answer...

Answer 7

The physical weight of the Lippert Components High-Speed Power Stabilizer Jack part #LC298707 is around 65 lbs. However, if you were instead referring to the weight capacity which is also another common question we get then I do no not have a…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

We have just what you need, the Go Power Portable Solar Panel with Digital Solar Controller, #34282610. This lets you place the solar panel where you need it for maximum sunlight while not having to place the camper in the sun too. For the later…

view full answer...