Replacement Antenna For A Voyager Backup Camera System WVOS43

Question

Question:

I need a replacement antenna for a WVOS43 voyager wireless camera. It has a female connection on the antenna. Do you have a replacement antenna. ?

asked by: Thom B

1

Helpful Expert Reply:

The correct replacement antenna for your Voyager WVOS43 camera system is the:

-Replacement Wireless Antenna for Voyager Backup Camera System # PXXHD0006301R.

Attached is a product review video for you to check out as well.

expert reply by: Bryce D

1

Answer 1

There isn't an adapter to connect the wiring of a Furrion camera to a Voyager. With that said you can pretty easily just cut the connectors off and then connect to the camera since it's only two wires.

view full answer...

Answer 2

According to the nice folks at Voyager, the #PXXHD0006301R is indeed the correct replacement antenna for their WVOM43 camera system.

view full answer...

Answer 3

My first thoughts on your Voyager WiSight Wireless System, #WVOS541, are, there is an issue getting a strong wireless signal. You've checked power to the monitor but what about the camera and antennae, please verify that too. If you are getting…

view full answer...

Answer 4

I have attached for you below the pairing procedure for the Voyager WiSight Wireless RV Backup Camera System part #ASA84YR. Please note, a mistake I have made in the past was applying power to the camera too soon, this cannot be done until the…

view full answer...

Answer 5

Unfortunately, the Replacement Voyager WiSight 2.0 Wireless RV Backup Camera Monitor #ASA27FR is only compatible with the Voyager WiSight 2.0 Wireless systems. Since the first generation monitors are now obsolete you'd have to upgrade your entire…

view full answer...

Answer 6

There were two different style cameras that came in the WVOS511 kit, which has since been discontinued. Each of the cameras had different antennas. One is straight on the newer model camera and the one has an elbow type on the older camera. An easy…

view full answer...

Answer 7

It sounds like you're needing the Global Link RV Baggage Door Slam Latch #295-000078 which measures 5" wide x 4-1/2" tall x 1-3/4" thick and has a recommended cutout 3-7/8" wide x 3-3/8" tall. Attached is a review video…

view full answer...

Answer 8

I have some measurements for you which will allow you to verify if the Replacement Amber Lens #A44AB will fit your 2023 Grand Design Imagine XLS 17MKE. This lens is 4" long by 1-1/2" tall, see image below. Unfortunately, only Grand Design…

view full answer...

Answer 9

The replacement antenna for the Voyager WiSight Wireless RV Backup Camera Monitor #WVOM541AP is part #VO54FR on our site. If you're looking for the replacement antenna for the camera #WVCMS130AP instead then that would be part #PXXHD0006301R that…

view full answer...

Answer 10

Since your trailer has the bracket #FRCBRKT-BL that would mean your trailer has the Furrion pre-wiring which is very common for newer RVs. The part #FOS43TASF is a fit for this and would be a really easy install. This gives you a monitor with a 4.3…

view full answer...

Answer 11

The Furrion camera system we have is a closed system and would not be compatible with the in-dash display so you would need to purchase GM's camera system to be able to connect to your display instead of having another monitor. If you do end up…

view full answer...

Answer 12

The pre-wiring of Furrion pre-wired RVs is basically just two wires as well as the Voyager harness like part #PSVCWVCMS130AP. One wire is the power wire which is the running light circuit and then the other is the ground so it really would just be a…

view full answer...