Can the etrailer Trailer Coupler Lock for Flat Lip 2-5/16" Ball Couplers Be Keyed Alike

Question

Question:

I am wanting to get the etrailer brand yellow trailer coupler lock and want to buy new. Are they keyed alike.

asked by: Greg S

0

Expert Reply:

The etrailer Trailer Coupler Lock for Flat Lip 2-5/16" Ball Coupler part # e98895 does have a keyed alike option you can select on the product page which will allow you to obtain multiple with the same key code.

expert reply by: Conner L

0

Answer 1

Correct, the etrailer.com Trailer Coupler Locks like part #e98895 or part #e98889 must all be purchased at the same time in order to take advantage of the keyed alike option. I wish we could match the lock to a set of keys you already have but this…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Answer 7

Hey Bill, so yeah we worded the fit of the lock you mentioned odd but it's not going to fit a 3 inch setup but we can help as we have the Blaylock EZ part #BLTL-60-40D that was designed for 3 inch diameter setups like you have.

view full answer...

Answer 8

Normally trailer coupler height is around 17 inches, from the ground to the bottom of the coupler, and most hitch manufacturers design their hitches to work with a ball mount that will end up very close to this measurement. I am including a link to…

view full answer...

Answer 9

While the Rack'Em Fitz-All Enclosed Trailer Ladder Rack #RA-28 was designed to fit on trailer with a rain gutter, we have had several install it on their trailer without rain gutters. I have also included our review video below where you can see…

view full answer...

Answer 10

We don't have an option that will allow for all of them to be keyed alike but I can get you down to one key for the hasp locks and another for the coupler lock. The Trimax Puck Locks for Trailer Door Hasps #TMX73FR comes with three keyed-alike…

view full answer...

Can the etrailer Trailer Coupler Lock for Flat Lip 2-5/16" Ball Couplers Be Keyed Alike

Product Page this Question was Asked From

Continue Researching