Correct Replacement Hub/Drum for Big Tex 16GN-25+5 Flatbed Gooseneck Trailer

Question

Question:

Will this fit 2022 16gn big tex 25+5 trailer

asked by: Yo

0

Expert Reply:

The Dexter Trailer Hub and Drum Assembly for 8,000-lb Nev-R-Lube Axles part # DX87XR is designed for Dexter 8,000 Lb Nev-R-Lube Axles which use 50mm bearings. We can't look up what parts any one particular trailer uses but if you crawl under the trailer and see "Dexter 8,000 Lb Nev-R-Lube Axle" on the axle tag you can be confident this is the correct fit for you. Otherwise, you'd need to reach out to the trailer manufacturer with your VIN for confirmation.

expert reply by: Conner L

0

Answer 1

The part that you're looking for is the Dexter Trailer Hub and Drum Assembly for 8,000-lb Nev-R-Lube Axles - 8 on 6-1/2 #DX87XR. This is the same as the part #8-385-81SP that you mentioned with the 9/16" studs except the DX87XR has the…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 9

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 10

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 11

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 12

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Correct Replacement Hub/Drum for Big Tex 16GN-25+5 Flatbed Gooseneck Trailer

Product Page this Question was Asked From

Continue Researching