Can Solera Smart Arm 12 Volt Awning Fit 2005 Fleetwood Discovery

Question

Question:

Will this fit on my 2005 Fleetwood Discovery? It has a top mounted awning rail

asked by: Stewart H

0

Expert Reply:

Yes, the Solera Smart Arm 12V Power RV Awning # LC517517 would fit your 2005 Fleetwood Discovery. It comes with everything you'd need to install too since you already have an awning rail present. Normally if that's not there you have to order that as well with # LC715217.

expert reply by: Jameson C

0

Answer 1

Yes, that is correct. For the Solera Awning Rail Extrusion #LC715217, you will have to buy 3 sections of 8' for a total of 24 feet and cut down to the size you need. Ensure you have the correct measurement by checking that you measured from…

view full answer...

Answer 2

The height or width of the Solera Awning Rail Extrusion #LC715217 that you referenced is 1-1/8 inch.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion…

view full answer...

Answer 9

Hey Johnny, There unfortunately isn't a guide to tell us the correct awning needed for your trailer so we'll need to get a measurement first to determine the best fit. I'm assuming you're replacing a different awning…

view full answer...

Answer 10

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from…

view full answer...

Answer 11

Brien, it sounds like you did your research so kudos to you, but the awning you're looking at is not going to work with the wind sensor. You'd need to use the Solera Smart Arm 12V Power RV Awning #LC517517 instead. You're also…

view full answer...

Answer 12

When choosing the slider you want to measure the outside front of box width including the flange. Then you need to select a slider that extends a minimum of 2-1/2 inches beyond each side of the box width. For example, the Black Solera Slider…

view full answer...

Can Solera Smart Arm 12 Volt Awning Fit 2005 Fleetwood Discovery

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching