Is There an Ideal Spacing For the MORryde Hitch Mounted Stabilizer Feet To Be Spread?
Question:
When you are setting up this device, what is the ideal spacing between feet to get the best results? Should it be as wide as possible?
asked by: Steven B
Helpful Expert Reply:
With the MORryde Hitch Mounted Stabilizer for 2" Trailer Hitches # MR22AR want to look at the angle you are creating on the arms. You want each arm to form a 45 degree angle to the ground to give you the strongest base. As no two vehicles will have the same height you want each foot to stick out the same height of your hitch. So if the hitch is 16" from the ground and you are on flat ground each leg will be 16" from center or 32" apart.
Product Page this Question was Asked From
MORryde Hitch Mounted Stabilizer for 2" Trailer Hitches
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Fifth Wheel Trailer
- Utility Trailer
- Stabilizer Jacks
- Steel
- Hitch Mount
- MORryde
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Wheel Cover
- Shop: SnapRing TireSavers RV Tire Covers for 27" to 29" Tires - Single Axle - White - Qty 2
- Shop: MORryde Hitch Mounted Stabilizer for 2" Trailer Hitches
- Search Results: tire and wheel covers
- Shop: Air Lift Load Controller Compressor System for Air Helper Springs- Heavy Duty - Dual Path
- Shop: Firestone Air Command Standard Duty Air Compressor - Analog - Dual Path
- Video: MORryde Hitch Mounted Stabilizer Review
- Video: Covercraft SnapRing TireSavers Tire Covers Review
- Video: Covercraft RV Covers - Tire and Wheel Covers - ST7002WH Review
- Shop: SnapRing TireSavers RV Tire Covers for 30" to 32" Tires - Single Axle - White - Qty 2
- Q&A: What Does MORryde Hitch Mounted Trailer Stabilizer # MR22AR Weigh
- Q&A: Recommended Undercarriage Spare Tire Mount for 5th Wheel RV
- Q&A: Class C Motorhome/RV Stabilizers That Are Not Permanently Attached To The Frame
- Video: Valterra Trailers and RVs Folding Manual Stabilizer Review
- Shop: Valterra Folding Manual Stabilizer for Trailers and RVs - 14" to 28" Tall - Aluminum
- Shop: Ark Drop Down Corner RV Stabilizer Jacks - 24" Long Corner Steadies - Silver - Qty 2
- Q&A: 7-Way RV Trailer Connector Wiring Diagram
- Q&A: Recommended SAE Wired 7 way Trailer Plug
- Search Results: morryde hitch stabilizer
- Search Results: hitch pin
- Search Results: c21582
- Search Results: 44649
- Article: Trailer Wiring Diagrams
- Video: Choosing the Right Trailer Wiring
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Shop: Trailer Hitch
- Search Results: 68149
- Shop: Trailer Wiring
- Article: Trailer Maintenance Schedule
- Q&A: 2022 Toyota Highlander Wiring for a 7-Way Blade Connector
on Trailer Jack
