Replacement Pressure Switch for Firestone Heavy Duty Air Compressor # F9499

Question

Question:

I have an air compressor that died. 2015 Chevy Silverado 1500. It was replaced by F9499 according to your site. The person that installed it last time. I dont think they did it correctly. With this system what pressure switch would I use? For the F9499, I didnt see an installation manual. Thank you for your time!

asked by: Joshua

0

Expert Reply:

Since the compressor part # F9499 is a heavy duty compressor rated for up to 150 psi the correct replacement pressure switch is the part # F9193.

expert reply by: Jameson C

0

Answer 1

The Firestone Air Compressor 24-3582-9210 is no longer available but we do have a suitable replacement for this, the Firestone Heavy Duty Air Compressor part #F9499. This is what Firestone recommends you use to replace the Firestone Air Compressor…

view full answer...

Answer 2

Yes, we have the Firestone Pressure Switch #F9193 that will turn on your Compressor #F9287 when pressure drops to 100psi. It will then shut back off when the pressure reaches 150psi inside your Tank #F9245

view full answer...

Answer 3

No, the Firestone Xtreme-Duty Air Compressor #F9287 is designed to connect right to the air tank. You will not need a relief valve for it to start.

view full answer...

Answer 4

While we don't have replacement parts for a Model 70LP actuator, we do have a great replacement for it. Like the 70LP, these actuators are a fit for a 2" hitch ball, but they just have a slightly larger capacity at 7,500 lbs. You didn't…

view full answer...

Answer 5

The Firestone Air Command II part #F2168 comes with a built-in pressure switch that will turn the air compressor kit on and off when the tank drops below or goes above the psi range which is 90-120 psi. If you like you can change this out for one…

view full answer...

Answer 6

Was there any manufacturer info on the existing coupler? Any part numbers? Unfortunately, there isn't an existing database that allows me to look up which hydraulic coupler was originally used on your 2005 Ranger Trail boat trailer. This being…

view full answer...

Answer 7

The Firestone Coil-to-Air-Spring Conversion Kit #F2595 does not come with a compressor and one is not technically required as you can manually inflate the bags with an external compressor, but realistically you will want a compressor kit. For a heavy…

view full answer...

Answer 8

The correct replacement compressor would be the #F9499 you had looked at. Just to be sure, I checked with my Firestone representative, who confirmed the compatibility of the replacement.

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 12

Another wire or harness is not needed on the 2023 Honda CR-V for the install of the Curt 4-Way Wiring Harness #C56370, but you do have to add 20 amp fuse to location #17 in the fuse box.

view full answer...