Does Fuse Need to Install with Hopkins Backup Camera HM50002
Question:
Backup camera with sensor 50002. I am transferring this over to my boat what size fuse should I include
asked by: Mark
0
Expert Reply:
The install of the Hopkins backup camera and alert system part # HM50002 does not require use of a fuse. Since it is powered by the reverse light circuit that would already be circuit protected.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Hopkins Smart Hitch Backup Camera and Hitch Aligner System
- Backup Camera
- Hitch Alignment Camera Systems
- Hardwired
- Dash Monitor
- 3.5 Inch Display
- Hopkins
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Maintenance Schedule
- Q&A: My Firestone Compressor Keeps Running Even When Air Bags Are Full
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What Size Wire Gauge is Used in Vision X 9007 Halogen Headlight Bulbs with Relay Harness
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Parts Needed to Swap a Trailer With Surge Brakes to Electric Brakes
- Q&A: Parts Needed To Install Trailer Brake Controller For a 2006 Toyota Tundra With Factory 7-Way
- Q&A: 2018 Ram 1500 Firestone Ride Rite Air Bag Kit Recommendation
- Article: Performance Chips and Modules
- Q&A: How To Select The Correct MORryde AllTrek Equalizer For a Tandem Axle Trailer
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Trailer Wiring Diagrams
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Can You Convert Tie Down Engineering LP8500 from Disc to Drum