What Replacement Keys do I Need for My Thule SUP Taxi XT # TH810001?

Question

Question:

Is there an option I can have if I decide not to go through a retailer to identify the lock cut with a master key?

asked by: Clyde S

0

Expert Reply:

Sorry to hear about your keys! With your provided information, we cannot know for sure what replacement keys you need for your Thule SUP Taxi XT # TH810001. This is because I confirmed with Thule that the lock cores that come with the # TH810001 are all coded to different key cuts. They are not all coded to N223.

With that being said, my tech at Thule suggested that the best way to proceed is to take one of the saddles to a local outdoor equipment department store and have them test your lock with the master key set. Once we know the lock core cut you have, we can definitely know for sure what replacement keys you need.

expert reply by: Bob C

0

Clyde

1/1/0001

Is there an option I can have if I decide not to go through a retailer to identify the lock cut with a master key?

Reply

Bob C.

5/16/2022

As a last resort, you can technically drill out the key cores you have on your # TH810001 and replace them with completely new lock cylinders. For this route, it is important to be extremely careful that you do not damage any other components of the carrier other than drilling out the locks. If you need assistance drilling, you can always reach out to a local locksmith. Once you drill out the locks, you need 4 replacement cores total. For that part, that is the Thule One-Key System Locks - Qty 4 # TH450400. This kit comes with 4 lock cores, 2 keys, and a change key. The cylinders are keyed-alike.

Reply

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 9

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 10

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...