Which MORryde Stepabove Fits Doorway Width of 28 inch and Height of 39 inch

Question

Question:

My distance between door flange is 28”. My height from the ground to floor is 39”. I have the mr65rr installed now but it’s not high enough. It’s dimensions are all the same as the 85rr except the number of steps. It looks like the 85rr is the one I need. Would just like to have a little support in my decision. Thanks

asked by: Mike L

0

Expert Reply:

Based on your door way width and the height of your door from the ground being 39 inches the correct MORryde Stepabove is the part # MR85RR that you referenced. This fits the entry door height range of 36-1/2 inch to 42-1/2 inch so your 39 inch doorway height would work great.

expert reply by: Jameson C

0

Answer 1

The MORryde StepAbove entry steps install inside your camper's doorframe, measure between the door frame flanges to determine your doorway width. The doorway threshold will be used as the mounting point, measure from the mounting point to the…

view full answer...

Answer 2

The MORryde StepAbove RV Steps #MR85RR weighs about 70 lbs. As far as the flip step, I assume you are referring to the MORryde Flip Tread RV Steps #MR42UR which weighs about 45 lbs. Both of these steps will fit your 28" wide door. Personally I…

view full answer...

Answer 3

It sounds like what you are lookin for is actually the replacement heavy duty shackle and bolt kit part #018-026-05 and the replacement shackle part #018-024-01. These are super thick at 1/2 inch and the correct length from bolt hole to bolt hole at…

view full answer...

Answer 4

Yes, the rubber cushion inside the Trailair Rota-Flex 5th Wheel Pin Box like part #LC328329 is essential to its functionality so if this is out of place or misaligned then that is certainly a cause for concern. That said, this is actually covered…

view full answer...

Answer 5

The difference is between just the MORryde Locking RV Storage Box #MR43RR and when you add the brackets at their widest setting. Just the box measures 25-3/4" but when you add the mounting brackets is when you'll see that 27-3/4" width…

view full answer...

Answer 6

The steps are approximately 19.415" in width for the MORryde Flip Tread RV Steps #MR42UR. To get wider steps you would need to size up in mounting width to something like the #MR28RR, but would need to have enough room for the steps to properly…

view full answer...

Answer 7

According to MORryde, you need 5-1/2 inches of clearance from inside the door threshold to fold up the steps you asked about, which are the following part number: - MORryde Flip Tread RV Steps for 23-3/4" to 28-1/4" Wide Doorways - 4 Steps…

view full answer...

Answer 8

Hey Bill, great question! The Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box - Lippert 1116 and 1716 - 30,000 lbs - 4.5K TW #GY45SR will fit in place of your MORryde RPB72-1716, but you'll want to verify that the 4.5K TW rating is best for your…

view full answer...