Fit of Galvanized Steel Plumbing Vent, # V2084

Question

Question:

will v 2084 fit over 1 1/2 pvc

asked by: George S

0

Expert Reply:

Yes, the Galvanized Steel Plumbing Vent, # V2084 will fit PVC pipe with an OD of 1-1/2".

expert reply by: Michael R

0

Answer 1

This is an unexpected configutation with the valve connected directly to the black tank. Nevertheless, it seems that a Valtera #F02-2106 Replacement Rubber Grommet would fix you right up. I think I would spring for some new Valterra #H03-0018 hose…

view full answer...

Answer 2

The LaSalle Bristol Toilet Floor Flange w/ Spigot for RV - ABS Plastic - 3" Hub x 4" Diameter #3446336347 will use the LaSalle Bristol ABS Solvent Cement - Black - 1/2 Pint #3447530889. You will simply then just need the length of 3…

view full answer...

Answer 3

If your RV black water pipe is threaded, we have an adapter that may give you the additional length you're looking for. The LaSalle Bristol Toilet Flange, part #3446336347, has a spigot end. The Valterra DWV Adapter, part #D50-2929, converts…

view full answer...

Answer 4

In order to help prevent leaking between the grommet and tank on the Replacement Rubber Grommet for RV Black Water Tanks part #F02-2106 it would be wise to use a sealant like part #LT37467 between the two surfaces. I am not sure if this is a…

view full answer...

Answer 5

The grove of the replacement Rubber Grommet for RV Black Water Tanks, #F02-2106 that you linked to is about 1/4". If your tank is 3/8", this will work, providing a tight seal.

view full answer...

Answer 6

To find the correct replacement flange for your trailer you'll first need to remove your current flange to see exactly how it was attached. Your current flange could be screwed onto the pipe or glued to it so you'll need to find out which…

view full answer...

Answer 7

Since the Valterra Rubber Tank Grommet #F02-2106 is rubber what you would need to use is a hose clamp to tighten and seal the grommet to the piping. You wouldn't need to use any type of sealant. For a hose clamp we have the part #H03-0009 which…

view full answer...

Answer 8

The backing plate and door for the Valterra City Water Inlet and Lockable Hatch for RVs #A01-2000BKVP is made of plastic.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Fit of Galvanized Steel Plumbing Vent, # V2084

Product Page this Question was Asked From

Continue Researching